ProMounts UA-PRO210 User Manual
Supports up to 100 lbs / 45 kg
Included Mounting Hardware You Will Need
UA-PRO210User’s Manual
5 & 6 mm hex key
1 UA-PRO210 mount (x1)
2 M4, M5 & M6 x 10 bolts (x4)
3 M4, M5 & M6 x 12 bolts (x4)
4 M4, M5 & M6 x 25 bolts (x4)
5 M4, M5 & M6 x 40 bolts (x4)
6 5/16” x 3” lag bolts (x2)
7 Concrete anchors (x2)
8 Ø 10 washers (x2)
9 Square washers
To reach
400x400 mm
use extensions
A Level
B Stud Finder
C Marker
D Drill
E 3/16” or 3/8” drill bit
F Hammer
400 mm VESA
extension (x4)
Arm
Cable Cover
Tilt
Wall Bracket
End Cover
Cover
Bracket
vBar
UA-PRO210WARNINGS & CAUTIONS
IT IS HIGHLY RECOMMENDED THAT THIS PRODUCT BE INSTALLED
BY A PROFESSIONAL.
PLEASE REVIEW THIS INSTRUCTION MANUAL COMPLETELY BEFORE STARTING THE INSTALLATION PROCESS.
WARNING: A WARNING alerts you to the possibility of serious injury or
death if you do not follow the instructions.
CAUTION: A CAUTION alerts you the possibility of damage or destruction of equipment if you do not follow the corresponding instruction.
WARNING: Improper installation can result in serious personal injury!
Make sure that the structural members can support a weight factor ve
times the total weight of the equipment. If not, reinforce the structure
before starting the installation.
WARNING: Be aware also of the potential for personal injury or damage to the unit if it is not adequately mounted.
WARNING: The installer is responsible for verifying that the wall or
ceiling to which the the mount is anchored will be safely support the
combined load of all attached components or other equipment.
Disclaimer:
ProMounts intends to make this
manual accurate and complete.
However, ProMounts makes no
claim that the information contained herein covers all details,
conditions or variations, nor does
it provide for every possible contingency in connection with the
installation or use of this product.
The information contained in this
document is subject to change
without notice or obligation of any
kind. ProMounts makes no representation of warranty, expressed
or implied, regarding the information contained herein. ProMounts
assumes no responsibility for accuracy, completeness or sufciency of the information contained in
this document.
WARNING: The weight of the display placed on the mount must not
exceed the maximum load capacity of the mount.
WARNING: Watch for pinch points. Do not put your ngers between
movable parts.
WARNING: Make sure the mount and brackets are correctly oriented.
CAUTION: Check the unit for shipping damage before you begin the
installation.
2
Loading...