Proline TTF50WP Operating Instructions Manual

PROLINE

TTF50WP

FREEZER

Operating instructions

1

Please read this instruction manual carefully before operation
Keep these instructions in a safe place for future reference

CONTENTS

Part Identification 3
Safety Information 4
Installation 4
Electrical Connection 5
Operating your freezer 6
Setting the Thermostat Control 6
Storing frozen food 6
Freezing fresh food 7
Making ice cubes 7
Defrosting 7
Cleaning your freezer 8
Reversing the door 8
Before calling for service 9
Do’s and Don’ts 10
Prolonged off periods 10
Technical data 11
Environmental notes 12
Help line numbers 12

2

PART IDENTIFICATION

1. Thermostat control

2. Drip tray

3. Shelf x 1

4. Door

3

Dear Customer:
Thank you for buying a Proline freezer. To ensure that you get the best results from
your new freezer, please take time to read through the simple instructions in this
manual.
Please ensure that the packing material is disposed of in accordance with the current
environmental requirements.

Safety information

This information is provided in the interest of your safety. Please read the following
carefully before carrying out the installation or use of the freezer.

If you are discarding an old freezer or refrigerator/chiller with a lock/catch fitted.
Ensure that it is left in a safe condition with the lock/catch broken to prevent the
entrapment of children.

Old refrigerator equipment may contain CFC’s which will damage the ozone layer.
When disposing of any refrigerator equipment please contact your local waste
disposal department for advise on safe disposal.

This appliance must be only used for its intended purpose freezing fresh food and
long term storage of frozen food and making ice cubes.

If the power cable requires replacement, this must only be undertaken by a suitably
qualified person as special purpose tools are required.

Installation

Position the freezer and allow to stand for two or three hours before it is turned on for
the first time to allow the system to settle. Do not position next to any heat source e.g.
cooker, boiler or in direct sunlight etc.

A clearance of 10cm must be left between the sides of the freezer and any adjacent
cabinets or walls to allow for adequate air circulation. The freezer is not designed for
a recessed installation (“building in”)

Install on a good firm level surface.

The freezer is heavy carry the freezer by the casing not the door.

For purpose of safety all electrical repairs or maintenance must be carried out by a
qualified electrician or service agent.

Warning the plug must be accessible after the freezer is in position

This appliance is for freezing fresh food and long term storage of frozen food and
making ice cubes.

If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.

4