Proline PL167GWA Instruction Manual

INSTRUCTION MANUAL

MODEL No.: PL167GWA

55cm UNDER COUNTER LARDER

Please read this instruction manual carefully before operation

Keep these instructions in a safe place for future reference

CONTENTS

Getting to know your larder fridge 1
Safety Information 2
Installation 2
Electrical Connection 3
Operating your refrigerator 4
Setting the Thermostat Control 4
Defrosting the fridge 4

Storage of fresh food in the refrigerator 5

Cleaning

your refrigerator 6
Replacing the lamp 6
Reversing the door

7

Maintenance 8
Trouble shooting 9

Do’s and Don’ts

Prolonged off periods 11

11

Technical d

ata 13

Important disposal instructions 14
If something doens't seem to work 14

Getting to know your larder fridge

1. Top Cover

2. Cabinet

3. Shelves

4. Crisper Box Cover

5. Crisper Box

6. Levelling Legs

7. Bottle Racks

8. Door Storage Compartment

9. Recessed Door Handle

10. Temperature Control Knob/Lamp

11. Door switch

Dear Customer:
Thank you for buying a Proline Refrigerator. To ensure that you get the best results
from your new refrigerator, please take time to read through the simple instructions in
this manual.
Please ensure that the packing material is disposed of in accordance with the current
environmental requirements.

Safety information

This information is provided in the interest of your safety. Please read the following
carefully before carrying out the installation or use of the refrigerator.

If you are discarding an old refrigerator / chiller with a lock/catch fitted.
Ensure that it is left in a safe condition with the lock / catch broken to prevent the
entrapment of children.

Old refrigerator equipment may contain CFC’s that will damage the ozone layer.
When disposing of any refrigerator equipment please contact your local waste
disposal department for advise on safe disposal.

This refrigerator must be only used for its intended purpose.

WARNING
This appliance is intended for domestic use only, any other use may invalidate the warranty

and might be dangerous.
Care must be taken that the coolant circuit must not be damaged at any time.

Installation

Position the refrigerator a

nd allow to stand for two or three hours before it is turned
on for the first time to allow the system to settle. Do not position next to any heat
source e.g. cooker, boiler or in direct sunlight etc.

A clearance of 10cm must be left between the sides of the appliance
and any adjacent cabinets or walls to allow for adequate air circulation.
This refrigerator is not designed for a recessed installation (“building in”).

Install on a good firm level surface, you can turn the front feet to stabalise any minor unevenness.

The refrigerator is heavy, carry the refrigerator by the casing not the door.

For purpose of safety all electrical repairs or maintenance must be carried out by a
qualified electrician or service agent.

Warning the plug must be accessible after the refrigerator is in position

This appliance is for refrigerating food.

If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid an electrical hazard.

ELECTRICAL CONNECTION

For your safety please read the following information

Warning: This appliance must be earthed.

The appliance must be connected to a 220-240 volts 50 cycle AC supply by
means of a three pin socket, suitably earthed and should be protected by a 13
amp fuse in the plug or a15 amp fuse in the consumer unit.

The appliance is supplied with a 13 amp 3 pin plug fitted with a 13 amp fuse.
Should the fuse require replacement, it must be replaced with a fuse rated
at 13 amp and approved to BS1362.

If the mains plug is unsuitable for the socket outlet in your home or is removed
for any other reason, then the cut off plug should be disposed of safely to
prevent the hazard of electric shock, Remove the fuse before disposal.

There is a danger of electric shock if the cut off plug is inserted into any 13
amp socket outlet.

How to wire a 13 amp plug.

Important
The wires in the mains lead on this appliance are coloured in accordance with
the following code:

Green and Yellow - Earth
Blue – Neutral
Brown – Live

As the colours may not correspond with the markings identifying
the terminals in your plug proceed as follows.

The green and yellow wire must be connected to the terminal in the plug
which is marked with the letter E or with the earth symbol or coloured
green and yellow.

The blue wire must be connected to the terminal marked N or coloured black.

The brown wire must be connected to the terminal marked L or coloured red.

Make sure the mains cord is held securely under the cord clamp.