Pro-ject Audio Amp Box SE Mono User Instruction

INSTRUCTIONS FOR USE

Pro-Ject Amp Box SE Mono

Dear music lover,

thank you for purchasing a PRO-JECT AUDIO amplifier. In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Connectors

Trigger

OUT

2x49V

Make all connections whilst the amplifier is disconnected from the power supply.

Connection to the preamplifier

The socket marked IN is for connecting the cables from your pre-amp or AV processor.

Connection to the speaker

The output terminal accept loudspeaker cables terminated with 4mm ∅ Banana plugs, spades connectors or naked wire.

Only connect one loudspeaker with an impedance not less than 4 Ohm.

Red terminal carry the positive signal (+), black connections the negative signal (–). Make sure the polarity of the connection is correct at each end of the cables.

Mains power connection

The unit is supplied with a power supply suitable for your country's mains supply. Check the label before connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug from the power supply to the 2x49V socket of the amplifier before connecting the power supply to the mains.

Never use any other DC power supply other than the one supplied with the unit.

Remote power on

The amplifier can be switched on & off via a special connection from the Pro-Ject Pre Box SE via the 2,5mm socket marked Trigger IN.

A 45cm long power-on cable (polarity accessories. The remote power-on signal can be relayed to further units via the Trigger OUT socket.

) is supplied for this purpose. Longer cables are available as

Stand-By

The pushbutton on the front panel of the unit alternately turns the power on or returns it to standby mode. The blue LED on the front panel shows that the unit is powered on.

+ 1 hidden pages