Pro-Ject CD Box DS User Manual

INSTRUCTIONS FOR USE

Pro-Ject CD Box DS

Dear music lover, thank you for purchasing a PRO-JECT AUDIO CD Box. In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Caution! Laser diode, discs to avoid, safety instructions

This product contains a laser diode of higher class than 1. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. Refer all servicing to qualified personnel.

If a disc is cracked, chipped, warped, or otherwise damaged, don't risk to play it. You could end up damaging the unit. This player is designed for use with fully circular, full size CDs only. Use of shaped discs is not recommended. The manufacturer and the distributor disclaims all liability arising in connection with the use of damaged or shaped discs.

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the

voltage in your area meets the voltage requirements printed on the power supply. The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily

accessible at all times. Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,

such as a flower vase on or near the device. Never spill any liquid on the device or the power supply. Never place any naked flame sources, such as lighted candles on or near the device. The product shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.

Never handle the device, the power supply while your hands are wet or damp.

Connectors

18V

Pro-Ject Audio Systems, Vienna, Austria

Make all connections whilst the CD player is disconnected from the power supply. Take care to connect the left and right channels correctly. The right channel is usually marked red,

the left channel black or white. Never use any other power supply than the one supplied with the unit.

Connection to the amplifier

Connect the Out socket to a line input (such as AUX) on your amplifier.

Connection to a external A/D-converter

Connect the Digital output socket to a coaxial digital input on the D/A converter or AV processor. Doing so allows you to use the signal in its digital for further digital processing.

Mains power connection

Connect the low voltage plug from the power supply to the Power 18V " socket before connecting the power supply to the mains.

+ 3 hidden pages