ProAc Response D-25 Brochure

To improve on the highly acclaimed Response 2.5
would have been a daunting task but for the
development of a new generation of highly efficient
and sensitive drive units. The faultless reproduction
throughout the frequency range which made the 2.5
such a world-beater has not only been sustained but
greatly intensified in the new D25. Good quality valve
or Class A transistor amplifiers with an output as low
as 10 watts will produce fine results from these
exciting new loudspeakers.

The original cabinet dimensions have been retained,
but there the similarity ends. The cabinets
themselves, handcrafted and finished in real wood
veneers, are extremely rigid and heavily damped as
before, but the introduction of a large flared port
beneath the plinths gives better interaction with the
listening room, making cabinet placement less critical.

ProAc RESPONSE D25

ProAc

RESPONSE D25

New vitality and
potency from an
internationally
acclaimed design

An entirely new 61⁄2” bass/midrange driver, built by
one of the UK’s leading studio monitor manufacturers,
is used in tandem with a radical new one inch soft
dome tweeter. This combination is harmonised
through a sophisticated HQC crossover network and
ProAc oxygen-free wiring, delivering exceptional
power handling, efficiency and sensitivity.

The D25 is like a breath of fresh air, with an
immediacy and dynamism which reaches out to touch
the listener. The improved sensitivity squeezes every
detail out of any type of recording and the classic
ProAc virtues of low colouration, fine balance and
sweet smoothness ensure an unforgettable listening
experience at a very reasonable price level.

Specification

Nominal Impedance 8 ohms

Recommended Amplifiers 10 to 200 watts

Frequency Response 20hz to 30Khz

Sensitivity 88db linear for 1 watt at 1 metre

Bass/Midrange Driver 6

1

⁄2” (165mm) ProAc unit with coated polypropylene cone on die-cast chassis

Tweeter ProAc 1” (25mm) soft dome with special surround and inner damping

Crossover HQC crossover using dedicated components wired throughout with multi-

strand oxygen-free cable. Split for optional bi-wiring and bi-amping.

Dimensions 42” (1066mm) high on plinths with conical feet

8

3

⁄4” (222mm) wide

10” (254mm) deep

Weight 57 lbs (26kg) /cabinet

Mode Floorstanding

Grille Acoustically transparent crimplene

Finish Available in the following real wood veneers: Black Ash, Maple, Mahogany,

Cherry, Yew, Ebony, Bird’s Eye Maple and other finishes to special order

* Due to our policy of continuous improvement all specifications are subject to change without notice. Cabinets pictured

are finished in Ebony real wood veneer. Since wood is a natural product, both colour and grain patterns may vary.

Highpoint House, Riding Road, Buckingham Road Industrial Estate, Brackley, Northamptonshire NN13 7BE

Telephone [phone] Fax [phone] Website www.proac-loudspeakers.com

ProAc RESPONSE D25

Printed in England