PRIVILEG PCTHR K6040 IN User Manual

EN
Ø 145 mm
Ø 145 mm
Ø 210 mm
Ø 180 mm
(*)
Ø 145 mm
Ø 210/120 mm
Ø 180 mm
(*)
Ø 210/120 mm
HOB INSTRUCTIONS
DE ES FR GB IT NL
PREPARING THE HOUSING UNIT
The hob must be tted in a worktop with a minimum thickness of 20 mm and a maximum of 50 mm.
There must be nothing between the hob and the oven (e.g. cables, insulating material, etc.).
An adjacent column unit must be installed at least 100 mm from the edge of the hob.
Read the hood instruction manual for the correct hood vertical distance from the hob.
* Residual heat indicator (only on some models)
Before use, remove:
adhesives stuck on the hob;
cardboard guards and protective plastic lm;
check whether the hob has been damaged during transport.
If in doubt, contact the After Sales Service.
Make sure that the voltage indicated on the rating plate is the same as the mains voltage.
Refer to the oven installation leaet for the cables connection.
If the worktop is made of wood, use the spring clips (A) and screws (B) provided (g. 1). To install the hob on other surfaces than wood (marble, stone, etc.) ask After Sales Service for the xing plates (g.2) code 4819 404 78697.
WARNING
All messages relevant to safety specify the potential risk to which they refer and indicate how to reduce the risk of injury, damage and electric shocks due to incorrect use of the appliance. Make sure to comply with the following:
If the surface is cracked, switch off the appliance to avoid the possibility of electric shock.
The appliance is not intended to be operated by means of an external
timer or separate remote control system.
Unattended cooking on a hob with fat or oil can be dangerous and may
Fig. 1
Fig. 2
result in re. NEVER try to extinguish a re with water, but switch off the appliance and then cover ame e.g. with a lid or a re blanket.
Danger of re: do not store items on the cooking surfaces.
Refer to the oven user and maintenance manual for further safety
information.
400011091599
OPERATION OF COOKING ZONES
The cooktop control knobs are on the control panel on the oven.
Set the knob to the desired power setting (see the instructions supplied with the oven).
To switch off the cooking zones, set the knob to position “0”.
Important: To avoid permanently damaging the glass-ceramic top, do not use:
Pots with bottoms that are not perfectly at.
Metal pots with enamelled bottom.
ENERGY SAVING
Use pots and pans whose bottom diameter is equal to that of the cooker plates, or slightly larger.
Only use at-bottomed pots and pans.
If possible, keep the pot covered when cooking.
Cook vegetables, potatoes, etc. with little water in order to cut down
cooking time.
A pressure cooker allows you to save even more energy and time.
ECO DESIGN DECLARATION
This appliance meets the eco design requirements of European regulation N. 66/2014, in conformity to the European standard EN 60350-2.
CARE AND MAINTENANCE Important: never clean the appliance with high pressure water or steam
cleaning equipment.
Clean the hob, when it is cool, after each use. This will prevent the build-up of dirt and make cleaning easier.
Use a clean cloth, absorbent kitchen wipes and washing up liquid or a specic glass ceramic cleaner.
Remove baked-on dirt with the special scraper tool (if provided) and specic cleaning products.
Any food spills should be cleaned off before they dry.
Do not use abrasive products, chlorine-based cleaners, oven-cleaner
spray or pan scourers.
AFTER SALES SERVICE Before you call the After Sales Service
Make sure that you cannot solve the problem yourself following the points described in chapter “Troubleshooting Guide”.
If after the above checks the fault still occurs, get in touch with the
nearest After Sales Service.
Please give:
a short description of the fault;
the exact type and model of hob;
service number (i.e., the number that follows the word SERVICE on the
rating plate under the hob itself). The service number is also indicated on the service leaet;
your full address;
your telephone number.
If any repairs are required, please contact an authorised After Sales Service (to guarantee that original spare parts will be used and repairs carried out correctly).
Failure to comply with these instructions may compromise the safety and quality of the product.
TROUBLESHOOTING GUIDE
The hob does not work:
Make sure that the power supply is on.
Turn the hob off and on again, to make sure that the problem has been
solved.
Make sure that the knob is not turned to “0”. Turn the multi-pole switch
to “Off” for a few minutes and then turn it back to “On”.
Loading...