Page 1
NOTE:
When using
3” paper,
install spacer
P/N: 93194
FieldPro 541
Quick Start Guide
This guide provides information on the daily use of the FP-541 printer.
For additional information, please refer to the FP-541 User Guide.
Press button to see
battery charge level.
4LED 100% charge
3LED 75%
2LED 50%
1LED 25%
Loosen hand strap
(not pictured) to
access battery
door.
Rotate knob 180
o
to unlock battery
door.
Drop in battery.
Close battery door
and rotate knob
180
o
to lock.
Press Paper door release button to
open the paper compartment door.
Pull small leader of paper out and
close paper door. “ Clicks” when
properly closed.
Battery Disposal
Only dispose of used batteries according to your local regulations. If
you do not know your local regulations, the Rechargeable Battery
Recycling Corporation (RBRC) is a non-profit organization created to
promote recycling of rechargeable batteries. For more information
visit www.call2recycle.org
Paper door release button
USB Data Port
Power Port
Control Panel
Paper Door
Tear paper
towards back of
printer
Printer features
Media Battery
© 2017 Printek LLC 3515 Lakeshore Drive, St. Joseph, MI 49085 PH:269-925-3200
www.printek.com | E: info@printek.com
Page 2
Function:
How to:
Power & Status
(Green/Red)
Battery
(Yellow)
Alert
(Red)
Indication
Power Button
Power up
Power down
Toggle IP over
USB on/off
Press & Release
Press & Hold
Press Twice
On
Off
On
Booting up
On
Off
Off
Ready
On
Off
Flashing
Paper Error/Lid Open
Paper feed button
Advance paper
Print setup
report
Press once
Press twice
Flashing
Off
Off
Job is arriving
Flashing
Off
Off
Job is printing
Flashing
Off
Flashing
IP over USB active
Solid, Flashes Off
Every 2 Seconds
Off
Off
Wireless Personal
Area Network active
Solid
Charging Battery
Flashing
Battery Low
FP-541 Quick Start Guide
Once the printer is connected via USB and in IP over USB mode it is temporarily not possible to access the Internet.
Control Panel indicators
Self-Test / Configuration print out
With power on, press the paper feed button twice quickly.
USB Access to Printer Web Pages
1. Turn the printer ON.
2. Connect a USB cable between the printer and a PC.
3. To access the FP-541 web page, push the Power button twice rapidly. This will put the printer into Configuration mode.
4. When the printer is in Configuration mode the POWER and FAULT LEDs will flash together.
a. Open browser on your PC and type 169.254.200.1 into the address bar of the browser and hit Enter - A login box should appear:
b. Type “0000” and hit Enter- you should now be at the home page for FP-541 Configuration.
5. To return the printer to normal operating mode, double click the POWER button. The Power LED will be returned to a solid light.
© 2017 Printek LLC 3515 Lakeshore Drive, St. Joseph, MI 49085 PH:269-925-3200
www.printek.com | E: info@printek.com
Loading...