Page 1
Sanding Block
3D MODEL ONLY
Jan Štech
VIEW IN BROWSER
updated 2. 3. 2024 | published 2. 3. 2024
Summary
Three small universal sanding blocks that should not be missing on any 3D
printer's desk.
Hobby & Makers > Tools
Tags: sandpaper sandingtool sandingblock
To assemble, you will need an M6 screw at least 25mm long with a
hexagonal head and an M6 nut. It is also possible to attach a thin strip of
foam to the sanding blocks, but it is not necessary.
See also:
18mm Utility Knife
https://www.printables.com/cs/model/788840-18mm-utility-knife
Caliper 0,5mm
https://www.printables.com/cs/model/
786337-caliper
Page 2
Honeycomb storage wall
tightening_wheel.stl
sanding_block_1.stl
For those of you who use honeycomb wall and
want to place these sanding blocks on them, I
have a holder in my models.https://
www.printables.com/en/model/759143honeycomb-holder
Other useful tools
Here are some more interesting tools for
makers.https://www.printables.com/cs/model/
776080-blade-scraper-saw-handle-wire-stripper
9mm Utility Knife
https://www.printables.com/cs/model/
757454-9mm-utility-knife
Model les
Page 3
License
sanding_block_2.stl
sanding_block_3.stl
rear_part_sanding_block_1.stl
rear_part_sanding_block_2_and_3.stl
washer.stl
This work is licensed under a
Creative Commons (4.0 International License)
Attribution—Noncommercial—No Derivatives
✖ | Sharing without ATTRIBUTION
✖ | Remix Culture allowed
✖ | Commercial Use
✖ | Free Cultural Works
✖ | Meets Open Denition
Loading...