Primo 320, 370 Assembly Guide

TOOLS REQUI RED FOR ASSEMBLY:
ADJUSTABLE WRE NCH OR 10MM WRENCH
LARGE PHI LLIPS HEAD S CREWDRIVER

EIGHT (8)

M6 X 20

STAINLESS

STEEL

PHILLIPS HEAD

SCREWS

(NOT IN CLUDED W ITH ALL CARTS)

FOUR (4) M6 X 16

STAINLESS STEEL

FLAT HEAD PHILL IPS SCREWS

* SEE SPEC IAL NOTE

ASSEMBLY INSTRUCTIONS

HANDLE METAL PARTS WITH CARE AS SOME MAY HAVE SHARP EDGES.

1. Remove all parts from the packaging and compare to the parts list.

2. SEE FIGURE 1 RIGHT. Remove 4 end caps prior to installation of shelf
brackets if previously installed.

3. SEE FIGURE 2 BELOW. Install the 4 brackets to the frame of the cart with
four M6 x 20 hex head bolts. (finger tighten only). *SEE SPECIAL NOTE
BEFORE PROCEEDING.

4. SEE FIGURE 3 BELOW. Fit the side shelves over the brackets and cart
frame. For an Oval XL, use the outer most set of holes and for a Oval LG use
the innermost set. The Oval JR shelf brackets have a single set of holes as
seen in figure 4.

5. Adjust both the shelf and brackets to align the openings in order to screw the
shelf to the cart. Being careful not to cross-thread the screws, finger tighten
each of the 4 phillips head screws per shelf before setting them tightly with the
screwdriver.

6. Once both shelves are installed, go back and tighten the brackets to the car t
frame. DO NOT USE POWERED SCREWDRIVERS, DRILLS, OR IMPACT
WRENCHES TO TIGHTEN THE BOLTS. This could result in damage to the cart
or grommets.

SPECIAL NOTE : Some carts ship with Shelf Brackets that have 3 holes facing the cart side

*

(illustration below). Shelf brackets with a 3rd hole accept a M6x16 Phillips Head fastener that
fastens through the outermost 3rd hole away from the center of the cart.

NOTE: LG 300 & XL 400 SHEL F

*

BRACKET S (TRIPLE HOLE)

FIGURE 4

FIGURE 1

TWO (2)

LEFT HAND

SHELF BRAC KETS

[phone]

NOTE: JR 200 S HELF BRACKETS (SINGLE H OLE)

TWO (2)

RIGHT HAND

SHELF BRAC KETS

INTS TALL THE SE SCREWS BEFO RE SIDE S HELF

FIGURE 3

FIGURE 2

Primo Cart Stainless Steel Side Tables

Assembly Instructions

PART NUMBER: #369 (FOR OVAL LG 300 & XL 400) , #319 (FOR JR 200)

www.primogrill.com