2002 by National Presto Industries, Inc.
Listed appliance. The following important safeguards are recommended by most portable appliance manufacturers.
IMPORTANT SAFEGUARDS
To reduce the risk of personal injury or property damage, when using electrical appliances basic safety precautions should always be
followed, including the following:
Do not touch hot surfaces. Use handles or knobs.
To protect against electrical shock or burns, do not immerse heat control or magnetic cord assembly in water or other liquid.
Close supervision is necessary when any appliance is used by or near children.
Be sure handle is properly assembled to basket and locked in place. See detailed assembly instructions on page 3.
Do not let children handle or put electrical cords or plugs in their mouths.
Always attach heat control and magnetic cord assembly to appliance rst, then plug cord into the wall outlet. To disconnect heat
control and magnetic cord, turn control to “OFF”, remove plug from wall outlet and cord assembly from heat control. Allow appli-
Unplug from outlet and remove heat control from appliance when not in use and before cleaning. Allow appliance to cool before
putting on or taking off parts, and before cleaning.
Do not operate any appliance with a damaged cord or plug or in the event the appliance malfunctions or has been damaged in any
manner. Return the appliance to the Presto Factory Service Department or to the nearest Presto Authorized Service Station for ex-
The use of accessory attachments not recommended by the appliance manufacturer may cause injuries.
Do not let cord hang over edge of table or counter or touch hot surfaces.
Do not place on or near a hot gas or electric burner or in a heated oven.
It is recommended that this appliance not be moved when it contains hot oil or other hot liquid. If it must be moved when it contains
hot oil or other hot liquid, use extreme caution.
Do not use appliance for other than intended use.
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY.
IMPORTANT CORD AND PLUG INFORMATION
A short power supply cord (or cord set) is provided to reduce the risk resulting from becoming entangled in or tripping over a longer
DO NOT USE WITH AN EXTENSION CORD.
Do not allow the cord to run underneath or around the unit. The magnetic cord may not detach easily if the cord is positioned in this
Connect the power supply cord to a polarized outlet only. As a safety feature, this appliance has a polarized plug (one blade is wider than
the other). This plug will only t in a polarized outlet one way. If the plug does not t fully in the outlet, reverse the plug. If it still does
not t, contact a quali ed electrician. Do not attempt to defeat this safety feature.
SAVE THESE INSTRUCTIONS
Due to the fact that the magnetic coupler end is polarized, it can only be attached to the heat control one way. When properly aligned,
the plug will magnetically attach itself to the heat control. If positioned upside down, it will not attach.
Important: The magnetic cord was designed to detach easily from the multi-cooker. As a result, if it is bumped or touched
during use it could possibly detach causing the unit to stop heating. Avoid contact with cord during operation. If contact oc-
curs, verify that the cord is still properly connected.
Plug the multi-cooker into a 120v AC electrical polarized outlet only.
cooking, the pilot light will go on and off indicating temperature is being maintained.
goes out. If you don’t want food to boil, start at Warm and increase heat until you reach the simmer point.
When cooking is complete, turn heat selector to OFF. Remove plug from wall outlet and then remove magnetic coupler end from heat
control. Allow appliance to cool and detach heat control from multi-cooker before cleaning.