Prestigio RoadRunner PCDVRR515 Quick Start Manual

Quick Start Guide
Prestigio RoadRunner PCDVRR515

EN

1. Packing List

• Prestigio car DVR • 15cm data cable

• Suction mount • Quick start guide

• Car charger • Warranty Card

• 3.6m power cable

2. Device Overview

1

LED light (Night mode)

10

OK button

2

USB port

11

Mic /SOS button

3

SD card slot

12

Power button

4

Lens

13

HDMI port

5

MIC

14

Up button

6

Reset

15

Menu button

7

Speaker

16

Down button

8

Mount hole

17

LCD display

9

Mode button

Quick Start Guide

Prestigio RoadRunner PCDVRR515

EN

Getting started

3. Power on/Power off

• Position the device in the vehicle using the suction mount and press the Power button
to turn it on. To power off the device press the button again.

• You can also connect the device to the car charger. It will automatically turn on and
start recording when the car engine starts. When the engine stops, the device will
automatically save the last file and turn off.

4. Charging

• Using the USB cable: Connect the device to the USB port of a Computer/Laptop

• Using the car charger: Connect the device to the car charger. The device will start
charging after the car engine is turned on. The device will automatically turn on and
start recording. When the engine stops, the device will automatically save the last file
and turn off.

• Normally it takes approximately 2-3 hours to fully charge the device. Operating the
device while charging with the Car Charger may extend the time of full charge.

Note:

Before using the device for the first time, please, connect it to the PC or notebook using
the USB cable provided to fully charge the battery. The battery is completely charged in
2-3 hours.

5. Inserting the Micro SD-card

• Before starting video recording, please, insert a Micro SD card (not included) into the
Micro SD card slot in the device.

• To extract the Micro SD card slightly push it inside the device, and remove.

Note:

After inserting the Micro SD card the device will automatically recognize it as default
storage and all the data will be saved on this card.

6. Recording

• Connect the device to car charger, when the car engine is turned on after 5 seconds,
the device will start loop video recording. When the car engine stops, the device will
save the last file and turn off after 15 seconds.

Notice:

»

Press OK button on loop video recording, the current file will be saved and the
device enters to standby mode.

»

When the Micro SD card is full, the device will delete the first unlocked video file
automatically.

7. Taking pictures

• Press the Mode button to select the picture mode.

• Press OK button to take photos, taken photos are saved on Micro SD Card.

• Press the Menu button in the picture mode, and then press up/down button to set
resolution and time.