USER GUIDE
PowerRite XT UPS
400 VA, and 600 VA
www.powerware.com.au
Table of Contents
Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
UPS Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Startup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Communication Port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Invensys Offices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Trademarks
Windows is a registered trademark of Microsoft Corporation.
All other brand and product names are trademarks or registered trademarks of their respective holders.
Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS!
SAVE THESE INSTRUCTIONS!
This User Guide contains important instructions for your PowerRite XT that must be followed
during installation and operation of the UPS.
The installation and use of this product must comply with all national, federal, state, municipal, or
local codes that apply. For assistance, call the Invensys Service or your local Invensys office.
If the PowerRite XT has been damaged during shipment, call your vendor immediately.
If the PowerRite XT is stored, the batteries should be recharged every 6 months. If stored above 25°
Celsius, recharge the batteries more often.
CAUTION!
Whenever the unit’s On/Off switch is “On,” there may be dangerous voltage present at the unit’s outlets. This
is true because the unit’s battery supplies power even if the unit is not plugged into the wall outlet. The unit
contains dangerous voltages.
To reduce the risk of electric shock, install the unit in a temperature-controlled and humidity-controlled indoor
area free of conductive contaminants. Do not allow liquids or other foreign objects to enter the UPS, or place
them near to it.
The power supply cord is intended to serve as the disconnect device. The socket-outlet must be near the
equipment and must be easily accessible.
All servicing of this equipment must be performed by qualified service personnel.
There are no user servicable parts within this UPS.
2
UPS Features
The PowerRite XT provides protection against power problems, including power outages,
brownouts, and surges. It also provides spike suppression and line noise filtering to protect your
equipment. Use the drawings below to identify features of the unit.
Start Up
1
Your PowerRite XT has a removable power cord. Connect the power cord to the back of the unit.
Plug the UPS into a wall outlet.
2
Let the unit charge the battery for at least 3 hours. You may use the unit while the battery charges,
but the battery backup runtime will be reduced until the battery is fully charged. This will take up
to 8 hours after a full discharge while the PowerRite XT is fully loaded.
3
To start the unit, press the On/Off switch (located in the centre of the front panel). When the unit
starts, it will beep and light the front panel LED. The green light should remain on. This indicates
normal operation.
4
Switch off the equipment you want to protect with battery backup and plug it into the outlets on the
rear of the PowerRite XT. This equipment will continue to operate from the battery when the input
line fails.
5
Switch on the protected equipment, one piece at a time. If the UPS beeps an alarm when you start
your equipment, the UPS may be overloaded. See the Troubleshooting section.
6
The PowerRite XT UPS is equipped with D.C. Start. To start the UPS when AC power is not
available, simply press the power switch.
3
On/Off
Switch
Indicator
LED
Output
Socket
Communication
Port
Input
Socket
and Fuse
PowerRite XT
PowerRite XT
Loading...