Page 1
Quick Assembly
Nut M6
Screw M6
Right rail slider
Left rail slider
Fixing stud
Fixing stud
Fixing stud
Fixing stud
Fixing stud
1. Package Contents
Right rail slider x 1
Left rail slider x 1
Nut M6 x 6
Screw M6 x 8
Fixing stud x 4
for Rack Mount Slider
2. Assembly Steps
Step 1: Insert 4 pieces of fixing nuts into the following locations of rail sliders. Be sure fix
them firmly. Then, pull apart two ends of rail sliders and place them in a chassis. Be sure the
pulling distance meets the depth of rack chassis and place fixing studs to the corresponding
holes on supporting columns. For example, if depth of rack chassis is 700mm, please pull the
length of rail sliders is 700mm.
V. 1.1
Page 2
M6 screw
M6 screw
M6 screw
M6 screw
Nuts x 3
Nuts x 3
Nuts x 3
Nuts x 3
Step 2: Use 4 pieces of M6 screws to mount rail sliders into chassis. See chart below:
Step 3: According to UPS height, put 6 pieces of nuts on proper location.
Step 4: Put UPS with assembled ears on the rail support.
Step 5: Fix the UPS in position with 4 screws.
Step 6: Assembly complete.
Loading...