powersoft D-Cell504, D-Cell504 IS Technical Note

TECHNICAL NOTE #15 rev. 01

Energy save mode

How to have Energy Save mode manually activated

1 Preliminary consideration

This ar ticle is related to the following products:

f D-Cell504

f D-Cell504 IS

2 Procedure

There are two methods to obtain the same result.

1.1 Method #1

You have to ground pin 16 on the CN1 connector, as shown in

FIGURE 1.

1.2 Method #2

You have to ground J1003 on the inter face board, as shown in

FIGURE 2.

FIGURE 2: Grounding J1003 on the interface board

© 2012 - 2013 Powersoft
powersoft_TN015_EnergySave_en_v1.0

FIGURE 1: Grounding Pin 16 on CN1 Connector

Keep This Technical Note For Future Reference

Via Enrico Conti, 5

50018 Scandicci (FI) Italy

Tel: [phone]
Fax: [phone]

General inquiries: [e-mail]

Sales: [e-mail]

Application & technical support: suppor [e-mail]

Service & maintenance: [e-mail]

www.powersoft-audio.com

© 2012 - 2013 Powersoft powersoft_TN015_EnergySave_en_v1.0