Power Acoustik PADVD-220, PADVD-220T User Manual

PADVD-220/ PADVD-220T

Single-DIN A/V Multimedia Source
Touch Sensor
DVD/CD/MP3/MP4
AM/FM Radio
Built-in TV tuner

Owner’s Manual

Take the time to read through this owner’s manual.
Familiarity with installation and operation procedures will help you obtain the best
Performance from your new DVD-receiver.

Table of Contents

Table of Contents.......................................................................................................................1

Important Safeguards.............................................................................................. ......... ..........2

Accessories .......................................................................................................................3

Installation/Un-Installation ..............................................................................................................4

Wiring Connections......................................................................................................................5

Detachable Control Panel ........................................................................................................6

Panel Controls……………..........................................................................................................7

IR Remote Controls ........................................................................................................................8

General Operations....................................................................................................................9

Digital Tuner..............................................................................................................................10

SD/MMC Cards/ USB Operations .............................................................................................11

Disc operations...................................................................................................................... 13

MP3 overview..................................................................................................................... .16

Setup MENU................................................................................................................................17

Anti-theft system..........................................................................................................................20

Note on Discs.............................................................................................................................. 21

Troubleshooting Guide .............................................................................................................22

Specification................. ........ ........ ........ ........ ........ ........ ........ ........ ........ .......... ........ .............. ....23

Page- 1

Important Safeguards

z Using the device at temperature below -10 may cause the breakage of the device. BEFORE ℃

USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED
TEMPERATURE!

z Read carefully through this manual to familiarize yourself with this high-quality sound system.
z Disconnect the vehicle's negative battery terminal while mounting and connecting the unit.
z When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with

a higher amperage rating may cause serious damage to the unit.

z DO NOT attempt to disassemble the unit. Laser beams from the optical pickup are dangerous to

the eyes.

z Make sure that pins or other foreign objects do not get inside the unit; they may cause

malfunctions, or create safety hazards such as electrical shock or laser beam exposure.

z If you have parked the car for a long time in hot or cold weather, wait until the temperature in the

car becomes normal before operating the unit.

z DO NOT open covers and do not repair yourself. Consult the dealer or an experienced

technician for help.

z Make sure you disconnect the power supply and aerial if you will not use the system for a long

period or during a thunderstorm.

z Make sure you disconnect the power supply if the system appears to be working incorrectly,（e. g,

making unusual sounds, smelling strange, emitting smokes from inside or liquid having gotten
inside it） Have a qualified technician check the system.

z The unit is designed for negative terminal of the battery, which is connected to the vehicle metal.

Please confirm it before installation.

z Do not allow the speaker wires to be shorted together when the unit is switched on. Otherwise it

may overload or burn out the power amplifier.

z Do not install the detachable panel before connecting the wire.
z Don't remove the detachable panel when encoding.

Page -2

Accessories

Package contains the following accessories for installation and operation of the unit.
(1) Washer, Spring

Washer, M5 Nut

1 each

(2) Mounting Strap 1

(3) Screw
(4) Bolt

(5) Mounting Collar 1

(6) Release Key 2

(7) Rubber Cushion 1

Owner’s Manual Remote Controller Panel Carrying Case

1
4

AUX IN Cable

Page- 3

Installation/Un-Installation

First complete the electrical connections, and then check them for correctness.
Installation

This unit can be installed in any dashboard having an opening as shown on the picture. The
dashboard should be 4.75 – 5.56 mm thick in order to be able to support the unit.

1. Insert mounting collar into the dashboard, and bend the mounting tabs out with a screwdriver.
Make sure that lock lever（

2. Secure the rear of the unit.
After fixing mounting bolt and power connector, fix the rear of the unit to the car body by rubber
cushion.

3. Insert trim plate.
When you prepare to insert trim plate, please check its direction. Once it was up side down, it
cannot be fixed.

※）is flush with the mounting collar (not projecting outward).

Lock lever（※）

Un-installation
Remove Trim Ring and insert Release Keys into left and right side-end holes as shown in below
picture and pull the unit out of the dashboard.

Page -4

Wiring Connections

Make sure you have good chassis ground. A good ground connection will eliminate most electrical
noise problems. A good chassis ground requires a tight connection to the vehicle’s metal chassis.
The area around the ground connection should be clean, bare metal without rust, paint, plastic, dust,
or dirt for a good electrical connection.

Using the ISO Connector

1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated.

2. For connections without the ISO connectors, check the wiring in the vehicle carefully before
connecting, incorrect connection may cause serious damage to this unit.

3. Cut the connector, connect the colored leads of the power cord to the car battery as shown in the
color code table below for speaker and power cable connections.

Location Function
Connector A Connector B

1 Rear Right(+)---Purple
2 Rear Right(-)---Purple/Black Stripe
3 Front Right(+)---Grey
4 Battery 12V (+)/yellow Front Right(-)---Grey/Black Stripe
5 Auto Antenna/blue Front Left(+)---White
6 Front Left((-)---White/Black Stripe
7 ACC+/red Rear Left(+)---Green
8 Ground/black Rear Left(-)---Green/Black Stripe

Page- 5

**TV antenna is for
PADVD-220T only.

Caution: Do not interchange the connection of the wiring!!!

For some car models you may need to modify wiring of the supplied power cord. Contact your
authorized car dealer before installing this unit.

Remark: When you back a car, screen display switch to Rear Camera automatically

Detachable Control Panel

Detaching the control panel

z Turn the Power off.
z Press OPEN button release the panel.
z Pull the panel out.

Attaching the control panel

z Insert the left side of the control panel into the main unit.
z Press the control panel right side until the “click” sound is heard.

Caution:

DO NOT insert the control panel from the right side. It can damage the control panel.
The control panel can easily be damaged by shocks. After removing it, place it in a protective case

and be careful not to drop it or subject it to strong shocks.
The rear connector that connects the main unit and the control panel is an extremely important part.

Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc.

Note:

If the control panel is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in
isopropyl alcohol to clean the socket on the back of the control panel.

Page -6

Panel Controls

1. Power/Mute

2. BAND

3. PREVIOUS

4. VOL +

5. NEXT

6. DISP

7. AS/PS

8. LCD

9. IR sensor

10. OPEN

11.MODE.

12.OK

13.VOL-

14. PRESET 1/play pause

15. PRESET 2./RPT

16. PRESET 3./INT

17. PRESET 4/RDM

18. PRESET 5/STOP

19. PRESET 6/MENU

20.AUX IN JACK

21.USB SLOT

22.SD SLOT

23.EJECT

24.DISC SLOT

25.RESET

Page- 7