Power Acoustik P-12A, P-15A User Manual

Thank you for purchasing this

Portable PA system. To gain the

most benefit fromt his PA system

and its sophisticated functions,

you need t read through this
manual thoroughly. Keep it in a
safe place for future reference.

Features

Main Features:

Tri-Pod, Flyable, & Floor Mounting Configuration
IMPP Vented Plastic Cabinet
2” Voicw Coil Woofer (12”)

2.5” Voicw Coil Woofer (15”)
1” Compression Driver
35-20kHz Frequency Response (12”)
35-20kHz Frequency Response (15”)
98dB (1w/1m) Sensitivity (12”)
101dB (1w/1m) Sensitivity (15”)

23.4”h x 15.1”w x 13.7”d; 35.2lbs (12”)

27.6”h x 18.1”w x 16.3”d; 44lbs (15”)

CAUTION:
WARNING:

TO REDUCE THE RISK OF FIRE REPLACE WITH ONLY
SAME TYPE AND RATING OF FUSE

TO REDUCE THE RISK OF FIRE OR ELECTRICS DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.

Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.

Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding prong.
The wide blade or the third prong are provided for safety. If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.

P-12A & P-15A

1,000W Max Power/400W RMS Class D Amplifier(12”)
1,200W Max Power/500W RMS Class D Amplifier(15”)

2 Ch. XLR Mic & Line Input
Stereo RCA & Phono Line Input
Mic & XLR Line-in Gain Control
2-Band Equalizer

The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of
uninsulated ‘dangerous voltage’ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of
electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accompanying the product.

P-12AUI & P-15AUI

USB Flash Drive Input
Playback Controls & LCD Display

iPod Input w/ Charging
* Other specifications same as P-12A/P-15A

Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
Only use attachments/accessories specified by the manufacturer.

Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination to avoid injury
from tip-over.
Unplug this apparatus during lightning storms or when unused for long
periods of time.

Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.

PRECAUTIONS

PLEASE READ CAREFULLY BEFORE PROCEEDING

WARNING

Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock, short-circuiting,
damages, fire or other hazards. These precautions include, but are not limited to, the following:

Power supply/Power cord

Only use the voltage specified as correct for the device. The required voltage
is printed on the name plate of the device.

Use only the included power cord.
Do not place the power cord near heat sources such as heaters or radiators,

do not excessively bend or otherwise damage the cord, place heavy objects
on it, or place it in a position where anyone could walk on, trip over, or roll
anything over it.

Be sure to connect to an appropriate outlet with a protective grounding
connection. Improper grounding can result in electrical shock

Do not open

Do not open the device or attempt to disassemble the internal parts or modify
them in any way. The device contains no user-serviceable parts. If it should
appear to be malfunctioning, discontinue use immediately and have it
inspected by qualified service personnel.

Please keep this manual in a safe place for future reference.

Water warning

Do not expose the device to rain, use it near water or in damp or wet
conditions, or place containers on it containing liquids which might spill into
any openings.

Never insert or remove an electric plug with wet hands.

If you notice any abnormality

If the power cord or plug becomes frayed or damaged, there is a sudden loss
of sound during use of the device, or any unusual smells or smoke should
appear, turn off the power switch, disconnect the electric plug from the
outlet immediately, and have the device inspected by qualified service
personnel.

If this device is dropped or damaged, immediately turn off the power switch,
disconnect the electric plug from the outlet, and have the device
inspected by qualified service personnel.

1

CAUTION

Always follow the basic precautions listed below to avoid the possibility of physical injury to you or others, or damage to the device or other
property. These precautions include, but are not limited to, the following:

Power supply/Power cord

Remove the electric plug from the outlet when the devices is not to
be used for extend periods of time, or during electrical storms.

When removing the electric plug from the device or an outlet, always
hold the plug itself and not the cord. Pulling by the cord can damage
it.

Location

When transporting or moving the device, always use two or more
people. Attempting to lift the device by yourself may damage your
back, result in other injury, or cause damage to the device itself.

Before moving the device, remove all connected cables.
When setting up the device, make sure that the AC outlet you are

using is easily accessible. If some trouble or malfunction occurs,
immediately turn off the power switch and disconnect the plug from
the outlet.

Do not use the device in a confined, poorly ventilated location. Make
sure that there is adequate space between the mixer and
surrounding walls or other devices: at least 1’ ft. at the side, 1’ ft.
behind and 1’ ft. above. If the mixer is to be used installed into the
speaker cabinet, make sure to allow adequate space between the
speaker and the surrounding walls or other devices: at least 1’ ft. at
the sides, 1’ ft. behind and 1’ ft. above. Inadequate ventilation can
result in overheating, possibly causing damage to the device(s), or
even fire.

Do not use the speaker’s handles for suspended installation. Doing
so could result in damage or personal injury.

Avoid setting all equalizer controls and faders to their maximum.
Depending on the condition of the connected devices, doing so may
cause feedback and may damage the speakers.

Do not expose the device to excessive dust or vibrations, or extreme
cold or heat (such as in direct sunlight, near a heater, or in a car
during the day) to prevent the possibility of panel disfiguration or
damage to the internal components.

Do not place the device in an unstable position where it might
accidentally fall over.

Do not block the vents. This mixer has ventilation holes at the top to
prevent the internal temperature from becoming too high. In
particular, do not place the device on its side or upside down.
Inadequate ventilation can result in overheating, possibly causing
damage to the device(s), or even fire.

Do not use the device in the vicinity of a TV, radio, stereo equipment,
mobile phone, or other electric devices. Doing so may result in noise,
both in the device itself and in the TV or radio next to it.

IMPORTANT

Please record the serial number of this unit in the space below.

Model:
Serial No.:

The serial number is located on the bottom or rear of the unit.
Retain this Owner’s Manual in a safe place for future reference.

Connections

Before connecting the device to other devices, turn off the power for
all devices. Before turning the power on or off for all devices, set all
volume levels to minimum.

For the SPEAKERS jacks, Use only the included speakers and
speakers cables. Use of other types of speakers and cables may
result in damage to the device(s), or even fire.

Handling Precautions

When turning on the AC power in your audio system, always turn on
the device LAST, to avoid speaker damage. When turning the power
off, the device should be turned off FIRST for the same reason.

Do not insert your fingers or hands in any gaps or openings on the
device (vents, ports, etc.).

Avoid inserting or dropping foreign objects (paper, plastic, metal, etc.)
into any gaps or openings on the device (vents, ports, etc.). If this
happens, turn off the power immediately and unplug the power cord
from the AC outlet. Then have the device inspected by qualified
service personnel.

Do not use the device for a long period of time at a high or
uncomfortable volume level, since this can cause permanent hearing
loss. If you experience any hearing loss or ringing in the ears, consult
a physician immediately.

Do not operate the device if the sound is distorting. Prolonged use in
this condition could cause overheating and result in fire.

Do not rest your weight on the device or place heavy objects on it,
and avoid use excessive force on the buttons, switches or
connectors.

Protective Circuit (poly switch)

All full-range loudspeakers are fitted with a self-resetting poly switch
that protects the high-frequency
excessive power. If a loudspeaker cabinet loses high-frequency
output, immediately remove power from the unit and wait for two to
three minutes. This should be long enough to allow the poly switch to
reset. Reapply power and check the performance of the high
frequency driver before continuing, with the power reduced to a level
that does not cause the poly switch to interrupt the signal.

driver from damage caused by

Interference From Cell Phone

Using a cell phone near the speaker system can induce noise. If this
occurs, move the cell phone further away from the speaker system.
Air blowing out of the bass reflex ports is normal, and often occurs
when the speaker is handing program material with heavy bass
content.

The manufacturer will not be responsible for damage caused by improper use
or modification to the device.

Always turn the power off when the device is not in use.
The performance of components with moving contacts, such as
switches, volume controls, and connectors, deteriorates over time.
Consult qualified service personnel about replacing defective parts.

2