Other Useful Inform ation:
Chargers have two l ights (can be combined in one bulb), when connecting a discharge d battery red/amber will illumina te, the light will turn green
during the charging cycle, this does not mean the charge ha s finished, the battery must remain on charge for a minimum of 12 Hours.
Batteries can sometimes take 2-3 rounds of golf before they become fully ‘activated’. We have found that on rare occasions there is not enough
capacity to complete a full round of golf. Our advice is to play only 9 holes on the their first outing.
Check with y our airline before a ttempting to transpo rt by air.
If you have a golf trolley batte ry that you would li ke to use with the n ew Plug’n’Play batte ry system you can pu rchase a fitting kit and case. The
kit requires some DIY but will c onvert your existing battery into a conv ienient Plug’n’Play battery for use with our new system.
Do Not:
Expose the charger to rain, moisture or damp, if you suspect any of these
have occurred then do not use the charger.
Wrap or cover the charger, as chargers generate heat in use.
Use the charger or battery if the leads, contacts or casi ngs are damaged.
Leave the ch arger connected to t he battery with the mains supply switche d off.
Leave the battery in a discharged condition, this will dramatically reduce the life
of the battery and your charger may be unable to recharge it.
Discharge your batt ery other than in normal use. The charger will not charge
an over-discharged battery.
Submerge the lithium battery in water, or deliberate ly spray with water or
other liquid s. To clean use a li ghtly dampened cloth . IMPORTANT - if
submerged un der water or if wate r may have entered d ue to damage to
casing, plac e outdoors in a non- combustible containe r covered in sand
well away fr om other flammable ma terial, and contact PowaKaddy or your
Local Author ity for further advi ce.
Leave on cha rge in temperatures below 0 C or expose the lithium battery to
temperatures below -5 C or above 40 C.
Use a non-Po waKaddy charger with your battery. A mis match of battery and
charger coul d cause damage.
Place the charger o n a hard flat heat resistant su rface, in a well
ventilated area.
Connect t he charger to t he battery bef ore switching o n the
power.
Charge yo ur battery for 12 hours befor e first use.
Switch of f the power bef ore disconnect ing the charger from the
battery.
Recharge your battery (1 2 Hours Minimu m) within 24 ho urs of
use, no matte r how many hol es played.
Leave the battery on cha rge even when not in regular use to
maintain optimum life an d performance. It is perfectly safe to
leave the battery plugged in on charge. Once charged the charger
will use virtually no electricity but guarantee you a fully charged
battery for your next round.
Secure th e battery when transporting e nsuring metal o bjects
cannot co me into contact with the termin als.
Ensure yo ur Plug’n’Play Lithium’s isol ation switch is in the off
position when the batter y is connected but not in use . for
example d uring transport ation.
Do:
Charge your Plug’n’Play Lithium battery with the iso lation switch in the off
position.
Additional information: Please refer to the product labels on your battery and charger.
Recycling and disposal: At the end of the battery’s life dispose at your local recycling centre.
*In normal conditions the Extended batteries will do 36 holes when used on a PowaKaddy trolley.
Conditions such as long or exceptionally hilly courses, wet ground conditions and excessively heavy
golf bags may reduce the range of the battery. Always fully recharge this battery regardless of the
number of holes played. Most lead acid batteries reach the end of their life in the second or third
season and often without any apparent reason. Very hot or cold weather does not help. Even batteries
that are treated identically have dierent life spans. Please note the Extended lead acid battery is not
available on the Plug’n’Play system although an adaptor plate is provided.
CONTACT US: PowaKaddy International Ltd, Castle Road, Sittingbourne, Kent ME10 3RN
T: 01795 473555 | E: sales@powakaddy.com | W: www.powakaddy.com
00656-01-0 2
PL U G’ n ’ PL A Y
TM
Lithium Battery 18 Hole/36 Hole
Standard Battery 18 Hole
Lithium Isolation Switch (1)= on (o)= off
Your FW3 trolley fe atures a new Plug’n’Play batter y system. Batteries available
are as follows:
Standard 18Hole E xtended 36Hole* Lithium 18Hol e Lithium Extended 36Hole*
Instruction Manual
0 1
Front wheel steering adjustment:
Your trolley will already be pre-set to run
straight. If you find your trolley tracking to the left or right you can re-adjust
this by releasing the front wheel lever and rotating the adjustment roller. Rotate up to
make your trolley track more to the LEFT and rotate down to track more to the RIGHT.
Once you are happy the trolley is running straight re-apply the lever to lock in position.
FW3 Controls:
Once your battery is connected your trolley will be ready to use.
The control functions are detailed below:
Central control knob:
Turn to control the speed of the trolley in normal operation. Press to
pause and resume your selected speed.
Power Indicator:
Displays whether power is being applied to the drive system. (on/off)
Thank you for purchasing the new PowaKaddy FW3. We hope you enjoy your new trolley and welcome your feedback and
comments. Please read these instructions carefully. Battery care is very important, please refer to the back page of this manual
for battery care instructions.
When you receive your new Powakaddy FW3 you will have the following:
1 x Trolley | 1 x Battery (lead acid or lithium) | 1 x Charger | 2 x Wheels | 1 x Instruction pack
IMPORTANT-
you must fully charge your battery for a minimum of
12 hrs before using your trolley. Always recharge your battery within
24 hrs of use. Failure to do so could reduce the life of your battery.
Note:
if you have purchased a Lithium or Lithium Extended product the battery is stored in the frame.
Remove the battery and activate using the isolation switch located on the underside of the battery.
(See image 2 for battery removal)
+ -
12h
Power Indicator
Central Control Knob
1
2
3
4
Maintenance:
Your PowaKaddy trolley is simple to maintain. Follow these steps for optimal performance.
Store in a dry, protected place.
Never jet wash your trolley or immerse it into water. Avoid using detergents, oils or solvents to clean your trolley. Wipe using a
damp cloth and always dry your trolley if used in wet conditions.
Occasionally remove the wheels and apply grease to the axle and moving parts.
Your serial number can be found on the underside of the central tube.
Off
On
Fit the wheels by pressing the yellow release clip and pushing onto the axle until the clutch is engaged. Note: the wheels can be
locked into two positions; push onto the inner groove to engage drive. The outer groove can be used when drive is not required.
To open, slide the main lock (highlighted below) forward to release the handle latch and open as shown below.
1
A
B
C
1
2
Plug’n’Play Battery System: Once your battery is charged
and trolley assembled connect your battery as shown.
Engage the rear of the battery first.
Press the front until the battery clips into position.
The trolleys power will automatically be connected.
To remove the battery depress the front latch (highlighted) and
lift the battery out. The lithium battery operates in the same way.
Note: The lithium battery can be stored within the tray for
transportation and storage.
Please ensure you de-activate the battery using the red
isolation switch located on the underside. Leaving your
battery in the on (1) position could lead to your battery
discharging or trolley activating during transportation.
PL U G’ n ’ PL A Y
TM
1
2
2
0 1
Loading...