Powakaddy C2i GPS Owner's Manual

OWNERS MANUAL

All PowaKaddy electric trolleys

have been awarded the Quiet Mark

by the Noise Abatement Society

The PowaKaddy Update App

Available to download from the

Apple App store and Google Play

Thank you for choosing the new PowaKaddy C2i GPS. Please read these instructions carefully. Battery care is very important,
please refer to section 13 in the back of this manual for battery care instructions.

When you receive your new PowaKaddy you will have the following:

1 x Trolley | 1 x Lithium Battery | 1 x Charger | 2 x Wheels | 1 x Instruction pack

+-

1 2h

7h

Note: Your Lithium or Lithium Extended battery is stored in the frame for transportation. Remove the battery and
activate using the isolation button located on the underside of the battery. The green LED must be iluminated
when using the trolley and during charging. (See Section 2 Plug‘n’Play™ for battery removal)

1

Getting Started

The rear wheels are assembled and released by pressing the black release clip and pushing onto the axle until the clutch is engaged.
Note: the wheels can be locked into two positions on the axle; push onto the inner groove to engage drive. The outer groove can be
used when drive is not required. To open the frame, pull the yellow release handle (1) down and unfold the front wheel so the frame is
flat. Release the cam lock lever under the handle right side (2) and then press the release button (3) and lift the handle up to open the
upper frame. Ensure the middle joint is open fully to the stop position on this joint before closing the same cam lock lever.

1 2 3

+-

IMPORTANT- you must fully charge your battery before use. Always recharge
your battery within 24 hrs of use. Failure to do so could reduce the life of your
battery. See Section 13 Battery Care.

On

A

2

PLUG ‘n’ PLAY

Your Freeway trolley features an innovative Plug’n’Play™ battery
system including sprung terminals and a locking feature to
maintain power connection over uneven terrain. Once your
battery is charged and trolley assembled connect your battery
as shown.

• Engage the rear of the battery first.

• Press the front until the battery clips into position.

The trolley’s power will automatically be connected.

To remove the battery depress the front latch and lift the front of
the battery out.

Note: The Lithium battery can be stored within the tray for
transportation. Please ensure you de-activate the battery using
the isolation button located on the underside. Leaving your
battery on with the Green LED iluminated could lead to your
battery discharging or trolley activating during transportation.

Front Wheel Adjustment

3

B

™

C

1

1

2

2

Your C2i GPS trolley will already be pre-set to run straight. If you
find your trolley is tracking to the left or right you can re-adjust this
by releasing the front wheel lever and rotating the adjustment roller.
Rotate up to make your trolley track more to the LEFT and rotate
down to track more to the RIGHT. Once you are happy the trolley is
running straight re-apply the lever to lock in position.

4

The PowaKaddy C2i GPS has a handle height adjust feature that allows you to position and lock the handle in 3 different positions
depending on your height. Once adjusted the frame will close and open to the same handle position each time so you only need
to adjust once. For convenience each trolley is supplied in the centre height position, which should be ideal for most users.

Should you need to adjust the handle height un screw the fastener in the centre of the upper joint (highlighted red) and lift the
height adjustment plate underneath shown below. There are 3 positions indicated on the upper joint and the corresponding
feature on the height adjust plate. Move the handle and upper frame up or down to the desired position and tighten the screw
again to secure at the new height.

Handle Height Adjustment

5

The C2i GPS has fully integrated GPS capability, taking away the need to carry external devices to manage your game. Consisting
of the latest technology, bright multi-function full colour daylight readable display and cutting-edge styling combined with a
powerful 230w motor.

Controls Overview

Central Control Dial:

• Rotate to adjust the speed of the trolley from 0 to 9.

• Press to pause and resume your selected speed.

• Press and hold to activate the automatic distance function.

• Navigate menu options / press to select or enter value.

Left Button:

• When connected to GPS, press to return to previous hole.

• Press and hold to toggle between total distance and trip

time and distance.

Right button:

• When connected to GPS, press to advance to the next hole.

• Press and hold to toggle between front, centre & back

distances and Hazard mode.

Left Button Right Button

Left + Right button:

Central Control Dial / Push Button

• Press and hold both buttons for 2 seconds to enter the
settings menu.

• Press and hold both buttons for 2 seconds to exit the
settings menu and return to previous screen.

USB Charging Port

USB Charging Port:

• Located on the underside of the handle. Open the hatch to
charge mobile devices. The output is rated to 5v/500mA
suitable for most USB devices*

*USB output voltage 5v/500mA compatible with most USB portable devices, please check
device manufacturers instructions before use. PowaKaddy International Ltd accepts no liability
for loss of data or damage from using the charging port with incompatible device.

GPS Map Updates:

• Your C2i GPS device is loaded with over 37,000 course
maps.

• You can update the GPS data using a smartphone or
mobile device via the Powakaddy App. See section 11
Updating Your PowaKaddy for more information.

6

Start Up

Main Menu

Once your battery is charged and connected your C2i GPS will be ready
to use. The display will illuminate showing the ‘Main Menu’ (see left), rotate
the centre control dial to select from the options and press to select the
following:

Play Golf:

• Move the cursor to Play Golf mode using the central control dial.

• Press the central control dial to enter Play Golf.

• The trolley will start searching for GPS signal. This can take up to 3

minutes depending on location and signal strength. For best results
operate away from buildings in an open sky position to receive the
signal from the satellites.

• If no signal is acquired after 5 minutes, a Low Signal message will be
displayed. Move to a better GPS signal strength area and the trolley
will continue searching. (The display will return to the searching icon to
reflect this).

You can operate the standard motor functions while the GPS device
identifies your location and local course information. Once the device has a
GPS lock the next time the trolley is stopped your nearest 5 local courses
will be displayed. Select the required course and the default display will load.

If you find yourself playing a certain course regularly you may wish to set
a ‘default course’. This will enable the trolley to load directly to the default
display. See Settings in section 9 for more information.

Searching

Select Course

Demo Mode:

Will allow the user to explore the display screens and trolley function without
requiring a GPS signal lock.

• Select ‘Demo’ from the start menu.

• The display shows the GPS searching screen and then will allow you to

choose from a select list of courses.

• Rotate the control dial to select from the list of course and press and
hold the control dial to confirm.

• The display will start in demo mode and will allow the normal trolley
function.

• Press and release the right button to toggle through the Front, Centre &
Back distances and Hazard mode. (

only to demonstrate the product and may not be accurate course information)

• After you have toggled past hazard mode the display will automatically
return to the Start Menu.

• Repeat the steps above to start Demo mode again.

Settings:

Allows you to alter settings such as time, distance units and set a user pin
lock. See Section 8 for further details.

Note: the information shown in demo mode is

7

Trolley Controls

Battery Gauge

Full
Charge

Half
Charge

Empty

Battery Gauge:

The battery gauge on the C2i GPS is displayed in the top right hand corner
of the default display. The charge state of your battery will determine how
much of the bar will illuminate (see left).

As you progress through the round the inner bar of the gauge will drop.
When the bar has fully extinguished it indicates that the battery is flat. When
your battery is new the bar may only drop a small amount during the entire
round. As your battery ages, you may lose more.

If the bar is completely extinguished; (1) you may not have not fully charged
your battery (2) your battery is nearing the end of its useful life and should be
replaced.