Poulan Pro PP270 Owner's Manual
PP270
PORTABLE POWER STEAM CLEANER
OWNER’S GUIDE
IMPORTANT SAFETY INSTRUCTIONS
This owner's guide and any additional inserts are considered part of the product. They contain
important information about safety, use, and disposal. Before using the product, please familiarize
yourself with all operating and safety instructions. Please keep all documents for future reference and
pass these documents on, together with the product, to any future owner. See our website for the most
current version of this owner’s guide.
INTENDED USE: This product is intended to be used indoors for household cleaning in the United
States and/or Canada. This product is not intended for commercial or industrial uses. The manufacturer
assumes no responsibility for damage or injury due to unauthorized use or product modication. Failure
to follow these directions will void the product warranty.
WARNING: Risk to Children and Impaired Persons
Supervision is required during the installation, operation, cleaning and maintenance of this product
by children under age 12 and anyone with reduced physical, sensory or mental capabilities.
Children should be supervised to ensure that they do not play with the appliance, its parts and
packaging material.
Directions to reduce risk of re, electrical shock, and injury:
1. Read all instructions before use.
2. If an extension cord is necessary, use a grounded, properly rated cord (15 ampere, 14 gauge). Use
care to position extension cord where it is least likely to be damaged or tripped over during use.
3. Before plugging power cord into electrical outlet, be sure that all electrical information on rating
label agrees with your power supply.
4. To reduce likelihood of circuit overload, DO NOT operate another high wattage appliance on the
same circuit as this unit.
5. To protect against risk of electrical shock, do not immerse unit in water or other liquids. Do not use
power cord as handle, let it hang over edges of counters, or be crimped or closed in doors.
6. Never yank power cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
7. Do not operate unit with a damaged power cord or if the unit has been dropped or damaged. To
avoid risk of electrical shock, do not disassemble unit; contact Poulan Pro Consumer Service for
examination and repair. Incorrect reassembly can cause a risk of electrical shock when unit is used.
8. A loose t between wall outlet (receptacle) and plug may cause overheating and distortion of the
plug. Discontinue use of the product in this outlet. Contact a qualied electrician to replace loose or
worn outlets.
9. Do not leave unit unattended while plugged in.
10. Do not use unit where aerosol-based products are being used, or where oxygen is
being administered.
11. Unit is only meant to be used with recommended model PP-270 accessories. Using other types of
attachments may cause damage to unit or injury.
12. If Lighted On/Off Switch does not illuminate when set to “ON” position while power cord is
plugged in, unit is not operating normally. Immediately disconnect cord from power supply, then
refer to troubleshooting guide of this manual for assistance.
13. Always turn unit off and unplug power cord before lling Reservoir with water. Do not attempt to
use unit without properly lling Reservoir.
14. When lling Reservoir, only water should be used in unit – other cleaning agents could damage
unit or cause injury. Distilled or de-mineralized water is highly recommended, in order to minimize
potential build-up of mineral deposits. Do not ll Reservoir with more than 25 oz. (739 ml.) of water.
15. To avoid burns from escaping steam when removing Reservoir cap to rell unit:
• Always allow unit to cool for 5-10 minutes.
• Press and hold Steam Trigger to release all remaining steam pressure.
2 | ENGLISH
16. To reduce risk of contact with hot water emitting from Main Nozzle, check appliance before
each use by positioning it away from body and turning it on. Do not operate unit if Main Nozzle
is blocked.
17. Burns can occur from touching hot metal parts, hot water, or steam. Do not touch Main Nozzle or
attempt to connect accessories while unit is in use. Do not touch bottom of Mop Head or attempt
to attach a Microber Pad by hand while unit is in use. Use caution when you turn unit upside-down
– there may be hot water in Reservoir.
18. Use caution when using unit on uneven surfaces, such as stairs.
19. When steaming any surface for the rst time, it is recommended that you consult the manufacturer’s
guidelines for material being steamed. For items in question, test on an inconspicuous area
before proceeding.
20. Steaming unsealed hardwood or unglazed ceramic surfaces is not recommended, and may result in
warping or damage to the surface. Steam may remove the sheen from surfaces treated with wax.
21. When steam mopping, never leave unit resting in one spot on any surface for any period of time –
prolonged exposure to heat and moisture may damage oor surfaces.
22. Do not allow power cord to touch hot surfaces during use. Bundle cord loosely when storing.
23. Always allow unit to cool (at least 30 minutes for complete cooling) and empty Reservoir before
storing. Do not store unit with a damp Microber Pad still attached.
24. This product for use on 120 volt electrical outlets. The cord has a plug as shown at A in Figure
65.1. An adapter, as shown at C, can be used to connect three-blade grounding-type plugs to
two-slot receptacles (it is not included with your product). The green grounding lug extending from
the adapter must be connected to a permanent ground such as a properly grounded outlet box.
An adapter should not be used if a three-slot grounded receptacle is available. *NOTE: A TWO-
PRONG ADAPTOR IS NOT INCLUDED WITH THIS PRODUCT.
Figure 65.1
FCC CONSUMER ADVISEMENT: This equipment may generate, use and/or radiate radio frequency
energy that may cause harmful interference to radio communications. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to contact Poulan Pro Consumer Service at 1-800-
711-6617. Changes or modication to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
SAVE THESE INSTRUCTIONS
Questions or comments?
poulanprosteam.com
•
help@poulanprosteam.com
•
1-800-711-6617
•
Speak your mind! We invite you to review this product online:
poulanprosteam.com/reviews
ENGLISH | 3
Product Information
The following features and accessories are included with your Portable Power Steam Cleaner.
Carefully inspect the packing material for all parts listed below. To obtain possible missing parts,
refer to Product Support on Page 13 of this manual for Consumer Service contact information.
5
7A
1
6
12
19
15
7
2
4
17
21
13
20
16
3A
3
14
18
8
9
22
10
11
UNIT FEATURES
& ACCESSORIES
1
Steam Hose
2
Main Nozzle
3
Steam Trigger
3A
Steam Trigger Lock
4
Steam Handle
5
Handle Cradle
6
Cord Wrap
7
Reservoir (internal)
7A
Reservoir Cap
8
Lighted On/Off Switch
9
Steam Indicator Light
10
Extension Wands (2)
11
Mop Head
12
Scrubbing Microber Pad
13
Microber Pad
14
Jet Nozzle
15
Nylon Utility Brushes (2)
16
Brass Utility Brushes (2)
17
Round Brush
18
Shoulder Strap
19
Storage Bag
20
Funnel
21
Measuring Cup
22
Squeegee
4 | ENGLISH
Assembling Your
Portable Power Steam Cleaner
STEAM CLEANING ACCESSORIES
WARNING: Do not try to connect accessories while unit is emitting steam.
EXTENSION WANDS
1. Select one of the Extension Wands. Insert end (A) of Wand onto Main Nozzle (B) with yellow
lock/release button slightly off center with hole. Fully insert and rotate wand slightly to allow
button to snap into hole.
2. Using the same instruction, attach remaining Extension Wand to the rst Wand. Both Exten-
sion Wands should now be connected to the Main Nozzle.
C A
B
MOP HEAD
1. Align Mop Head with open end of Extension Wand, so that hole in Mop Head aligns with yel-
low lock/release button on Wand.
2. Press down on yellow lock/release button. While continuing to hold button down, slide Mop
Head onto Extension Wand (See gure 1-A). Fully insert and rotate wand slightly until button
snaps through hole (See gure 1-B).
NOTE: Do not use excessive force when mopping or using Extension Wands as this
may cause the Wands to break.
FIGURE 1
A
B
ENGLISH | 5
Loading...