Poulan Pro PP11TEP30 Owner's Manual
IMPORTANT MANUAL Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PP11TEP30
SNOW THROWER
Always Wear Eye Protection During Operation
WARNING:
Read the Owner's Manual and
fol low all Warnings and Safety
In struc tions. Fail ure to do so
can result in serious injury.
406860 Rev. 2 10.27.06 BY
Printed in U.S.A.
REPAIR PARTS SNOW THROWER - MODEL PP11TEP30 (96198000700)
AUGER HOUSING / IMPELLER ASSEMBLY
16
14
5
7
15
9
8
4
6
6
13
12
10
51
7
9
36
37
38
47
11
42
44
27
45
41
50
42
43
43
46
6
54
24
21
48
20
52
18
19
10
49
33
28
22
32
55
53
35
26
25
34
17
19
40
30
20
39
57
27
28
17
55
19
52
24
21
10
53
54
18
26
20
29
25
31
56
REPAIR PARTS SNOW THROWER - MODEL PP11TEP30 (96198000700)
AUGER HOUSING / IMPELLER ASSEMBLY
KEY PART
NO. NO. DESCRIPTION
4 191079 Pulley, Impeller
5 188909 Bearing Assembly, Flange
6 198541 Nut, Hex Flange 5/16-18
7 180355 Bolt, Flat Head, Carriage
5/16-18 x 5/8
8 72270505 Bolt, Carriage 5/16-18
9 199879 Bolt, Hex Head
10 404927X428 Housing, Auger
11 404933X479 Bar, Scraper
12 178675X008 Bracket, Corner Discharge
13 175322 Base, Discharge Chute
14 10040500 Washer, Lock 5/16
15 19111507 Washer, Flat
16 74950512 Screw, Hex Head 5/16-18 x 3/4
17 405637 Grease Fitting
18 179582 Screw, Hex Head 5/16 x 1
19 73800400 Nut, Hex Lock 1/4-20
20 198541 Nut, Hex Lock 5/16-18
21 401347 Washer, Flat
22 178777X479 Skid Plate, RH
24 128638 Wing Nut
25 72270506 Bolt, Carriage 5/16-18 x 3/4
26 174658 Bearing, Auger
27 174697 Washer, Thrust, 1"
28 198636 Bolt, Shear
29 174762X479 Skid Plate, LH
30 405973X479 Auger Assembly, RH
KEY PART
NO. NO. DESCRIPTION
31 405972X479 Auger Assembly, LH
32 407768 O-Ring
33 407769 Bushing, Flange 3/4
34 174681 Washer, Thrust 3/4
35 174684 Bearing, Thrust 3/4
36 407757 Shaft, Impeller
37 174683 Washer, Thrust 5/8
38 407758 Bushing, Flange 5/8
39 407767 Screw, Hex Head 5/16-18 x 3/4
40 407760 Plug, Case
41 407761 Housing, Gearbox, RH
42 407770 Seal, Oil
43 407762 Bushing, Flange, 1"
44 189282 Key, Square 1/4 x 1/4 x 7/8
45 407763 Gear, Worm
46 407764 Shaft, Auger
47 407765 Housing, Gearbox, LH
48 175321X479 Impeller Assembly
49 74780426 Screw, Hex Head 1/4-20 x 1-5/8
50 407766 Gasket, Gearbox
51 7836M Pin, Roll 3/16 x 1-1/8
52 181160X479 Bar, Drift Cutter
53 198648 Bolt, Shoulder
54 198709 Stop
55 198638 Spacer
56 180684 Multi-Wrench
57 196710 Gearbox Assembly
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm
IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
21
REPAIR PARTS SNOW THROWER - MODEL PP11TEP30 (96198000700)
CONTROL PANEL / DISCHARGE CHUTE
19
1
2
2
2
22
2
6
26
23
3
22
27
28
4
5
6
9
25
20
29
31
23
30
27
10
11
16
7
18
12
17
14
8
3
13
15
8
22
REPAIR PARTS SNOW THROWER - MODEL PP11TEP30 (96198000700)
CONTROL PANEL / DISCHARGE CHUTE
KEY PART
NO. NO. DESCRIPTION
1 183334 Knob, Lever
2 17501010 Screw #10-24 x 5/8
3 198475 Control Assembly, Defl ector
4 73800600 Nut, Lock 3/8-16
5 19131316 Washer, Flat 3/8
6 198473 Control Assembly, Chute Rotater
7 405784X479 Support, Pivot
9 184505 Spring, Defl ector
10 179829 Bolt, Shoulder
11 179246 Washer, Friction, Nylon
12 191730 Nut, Lock 1/4-20
13 72250505 Bolt, Carriage 5/16-18
14 751153 Nut, Lock 5/16-18
15 404770X428 Chute Assembly
16 178633X428 Defl ector Assembly
17 179145 Seal, Defl ector
18 128415 Rivet, Blind
19 183333 Knob, Speed Control Lever
20 72270506 Bolt, Carriage 5/16-18 x 3/4
22 74041024 Screw #10-24 x 1-1/2
23 188303 Control Assembly, Power Steering
25 198541 Nut, Lock 5/16-18
26 198474 Lever Assembly, Speed Control
27 169675 Retainer, Hairpin
28 180445 Rod, Upper, Speed Control
29 187716 Rod, Lower, Speed Control
30 192710 Clamp, Mounting, Clean-Out Tool
31 192199 Tool, Clean-Out
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm
IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
23
Loading...