Poulan Pro PP105TES27 Owner's Manual
IMPORTANT MANUAL Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PP105TES27
SNOW THROWER
Always Wear Eye Protection During Operation
WARNING:
Read the Owner's Manual and
fol low all Warnings and Safety
In struc tions. Fail ure to do so
can result in serious injury.
406482 Rev. 1 10.24.06 BY
Printed in U.S.A.
REPAIR PARTS SNOW THROWER - MODEL PP105TES27 (96198000300)
AUGER HOUSING / IMPELLER ASSEMBLY
16
14
5
7
15
9
8
6
4
6
6
13
12
10
51
7
9
36
37
38
47
11
42
44
27
45
41
50
42
43
46
43
48
19
10
49
33
28
32
55
35
34
19
40
39
27
28
17
55
19
26
10
18
20
29
25
31
18
26
22
25
20
17
30
57
56
20
REPAIR PARTS SNOW THROWER - MODEL PP105TES27 (96198000300)
AUGER HOUSING / IMPELLER ASSEMBLY
KEY PART
NO. NO. DESCRIPTION
4 191079 Pulley, Impeller
5 188909 Bearing Assembly, Flange
6 198541 Nut, Hex Flange 5/16-18
7 180355 Bolt, Flat Head, Carriage 5/16-18 x 5/8
8 72270505 Bolt, Carriage 5/16-18
9 199879 Bolt, Hex Head
10 404926X428 Housing, Auger
11 404932X479 Bar, Scraper
12 178675X008 Bracket, Corner Discharge
13 175322 Base, Discharge Chute
14 10040500 Washer, Lock 5/16
15 19111507 Washer, Flat
16 74950512 Screw, Hex Head 5/16-18 x 3/4
17 405637 Grease Fitting
18 179582 Screw, Hex Head 5/16 x 1
19 73800400 Nut, Hex Lock 1/4-20
20 198541 Nut, Hex Lock 5/16-18
22 178777X479 Skid Plate, RH
25 72270506 Bolt, Carriage 5/16-18 x 3/4
26 174658 Bearing, Auger
27 174697 Washer, Thrust, 1"
28 198636 Bolt, Shear
29 174762X479 Skid Plate, LH
30 405977X479 Auger Assembly, RH
31 405976X479 Auger Assembly, LH
32 407768 O-Ring
33 407769 Bushing, Flange 3/4
34 174681 Washer, Thrust 3/4
35 174684 Bearing, Thrust 3/4
36 407757 Shaft, Impeller
37 174683 Washer, Thrust 5/8
38 407758 Bushing, Flange 5/8
39 407767 Screw, Hex Head 5/16-18 x 3/4
40 407760 Plug, Case
41 407761 Housing, Gearbox, RH
42 407770 Seal, Oil
43 407762 Bushing, Flange, 1"
44 189282 Key, Square 1/4 x 1/4 x 7/8
45 407763 Gear, Worm
46 407764 Shaft, Auger
47 407765 Housing, Gearbox, LH
48 175321X479 Impeller Assembly
49 74780426 Screw, Hex Head 1/4-20 x 1-5/8
50 407766 Gasket, Gearbox
51 7836M Pin, Roll 3/16 x 1-1/8
55 198638 Spacer
56 180684 Multi-Wrench
57 196710 Gearbox Assembly
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm
IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
21
REPAIR PARTS SNOW THROWER - MODEL PP105TES27 (96198000300)
CONTROL PANEL / DISCHARGE CHUTE
19
1
2
2
2
22
6
26
23
22
27
28
4
20
5
25
29
6
16
13
14
31
23
30
27
9
7
18
21
3
17
12
14
8
10
15
8
22
REPAIR PARTS SNOW THROWER - MODEL PP105TES27 (96198000300)
CONTROL PANEL / DISCHARGE CHUTE
KEY PART
NO. NO. DESCRIPTION
1 183334 Knob, Lever
2 17501010 Screw #10-24 x 5/8
3 179096X479 Strap, Slotted
4 73800600 Nut, Lock 3/8-16
5 19131316 Washer, Flat 3/8
6 198473 Control Assembly, Chute Rotater
7 405784X479 Support, Pivot
8 150078 Screw, Hex Head 5/16-18 x 3/4
9 189713X428 Knob, Defl ector
10 185600 Bolt, Shoulder
12 191730 Nut, Lock 1/4-20
13 72250505 Bolt, Carriage 5/16-18
14 179246 Nut, Lock 5/16-18
15 404770X428 Chute Assembly
16 178633X428 Defl ector Assembly
17 179145 Seal, Defl ector
18 128415 Rivet, Blind
19 183333 Knob, Speed Control Lever
20 72270506 Bolt, Carriage 5/16-18 x 3/4
21 155415 Washer, Flat
22 74041024 Screw #10-24 x 1-1/2
23 188303 Control Assembly, Power Steering
25 198541 Nut, Lock 5/16-18
26 198474 Lever Assembly, Speed Control
27 169675 Retainer, Hairpin
28 180445 Rod, Upper, Speed Control
29 187716 Rod, Lower, Speed Control
30 192710 Clamp, Mounting, Clean-Out Tool
31 192199 Tool, Clean-Out
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm
IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
23
Loading...