Pottery Barn Cameron Craft Cubby Assembly Instruction
pottery barn kids
(E)
CAMERON CRAFT CUBBY
PRE-ASSEMBLY:
• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when
used in conjunction with the asse mbly instruction s.
• For your safety and ea se, assembly by two adults is recommended.
• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface.
Use care as some parts or hardw a re may ha ve sh arp poin ts or edge s.
• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.
• Use the parts and hardware lists to identify and separate each of the pieces included.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause
the bolts to misalign during assembly.
• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.
PARTS INCLUDED:
(A) Top Panel – 1pc
(B) Bottom Panel – 1pc
(C) Left Side Panel – 1pc
(D) Right Side Panel – 1pc
Back Panel –1pc
TOOLS REQUIRED:
Philips Screwdriver (Not included)
(F) Large Shelf – 1pc
(G) Small Shelf – 1pc
(H) Door – 1pc
(I) Drawer Box – 1pc
(J) Wooden Rod -1pc
C.
A.
J.
G.
H.
F.
I.
B.
E.
D.
HARDWARE INCLUDED:
(K) Allen Key – 1pc
(O) Plastic Cap – 2pcs
(L) Allen Bolt 1/4”x28mm – 8p cs
(P) T-Shape Bracket – 2pcs
(M) Spring Washer – 8pcs
(Q) Square Bracket – 1pcs
(N) Flat Washer – 8pcs
(R) Wood Screw 3 x12mm
– 22pcs
ASSEMBLY INSTRUCTIONS:
1. Place the Right Side Panel (D) on the working surface. Align and connect the wooden dowels on
Large/Small Shelf (F&G) to the pre-drilled hole s on the Righ t Side Pa ne l (D). (F ig . 1)
2. Insert a Plastic Cap (O) into the pre-drilled hole on the Right Side Panel (D), align and connect the Door
(H) onto the Plastic Cap (O). Make sure the wooden knob on the Door (H) is close to the end of the
wooden cleats on the Right Side Panel. (Fig. 2)
F.
G.
H.
Fig. 1 Fig 2
O.
D.
Page 1/4
3. Insert the remaining Plastic Cap (O) into the pre-drilled hole on the Left Side Panel (C) and place the Left
Side Panel (C) on the assembled piece. (Fig. 3)
4. Align and connect the Bottom Panel (B) to the assembled piece. Slide a Spring Washer (M), Flat Washer
(N) onto an Allen Bolt (L). Insert the Allen Bolt (L) from bottom of the Bottom Panel (B) into the pre-drilled
holes on the Left/Righ t Panel. Repeat with anoth er (3) Allen Bolts. (Fig. 4)
C.
O.
Fig. 3
B.
Fig. 4
5. Slide the Back Panel (E) into the grooves on the Left/Right Side Panel. Use (6) Wood Screws to secure
the Back Panel (E) to the Large/Small Shelf (F&G). (Fig. 5)
Fig. 5
Page 2/4
Loading...