Pottery Barn Big Wheel Twin Full Bed Assembly Instruction

pottery barn kids

tractor bed

PRE-ASSEMBLY:

• Remove all parts and hardw are from the box and lay out on a clean, carp eted, or scratch-free work surfa ce, as this will
avoid damaging any parts during assembly. The shipping box provides an ideal work surface. Do not dispose of any
contents until assembly is completed to avoid accidentally discarding small parts or hardware.

• Two peopl e re commend ed for ea se o f asse mb ly.

• Use the parts and hardware lists to identify and sepa rate each of the pieces in cl uded.

• The illustrations provided allow for easier assembly w hen used in conj unction w i th the assemb ly in stru ction s.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the bolts

to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood.

PARTS INCLUDED:

(A) Headboard - 1pc
(B) Footboard - 1pc
(C) Left Side rail - 1pc
(D) Right Side rail - 1pc
(E) Foot Panel - 1pc
(F) Step Ladder - 1pc
(G) Bed Slats – 1 set

G

E

HARDWA RE ENCLOSED:

(H) Barrel Nut - 8pcs (M) Washer - 18pcs

(I) 5/16" x 5-1/2" Bolt - 4pcs (N) Spring Washer - 18pcs

(J) 5/16" x 4" Bolt - 4pcs (O) #8 x 25mm Screw
Twin Bed – 30pcs
Full Bed – 28pcs
(K) 5/16" x 1" Bolt - 16pcs (P) Wheel - 4pcs

(L) 5/16" x 3/4" Bolt - 2pcs (Q) Spanner - 1pc

(R) Allen key (4mm & 5mm) - 2pcs

TOOLS REQUIRED:

Phillips head screwdriver (not included)

ASSEMBLY INSTRUCTIONS:

1. Position the Side rails (C) and (D) exactly as shown. (Fig 1) Attach the Wheel (P) into pre-drilled holes on

the side rails by using the 5/16" x 1" Bolt (K), Spring Washer (N), and Washer (M) Tighten with the enclosed

Spanner (Q). Repeat same process for the other 3 Wheels (Fig.1)

(Fig 1)

D

2. Position the Side rails with wheels (assembled in Step 1) to the Headboard (A), and insert the dowels into the

top two holes as shown. (Fig. 2) Insert (2) Barrel nuts (H) into the pre-drilled holes on one of the Side rails (C),

and then (2) 5/16" x 5-1/2" Bolts (I) through the pre-drilled holes on the Headboard (A). Tighten the connection

with the Allen key provided (R). Repeat this step with the remaining Side rail (C) at the other end of the

Headboard (A), and both sides of the Footboard (B). (Fig. 2 & 3). Note: Ensure the Barrel Nuts are positioned as

shown in the images before attempting to insert and the 5/16" x 4" Bolts (J).