pottery barn kids
BERKELEY SHORT DRESSER
PRE-ASSEMBLY:
• Remove all parts and hardware from the box and lay out on a clear carpeted or
scratched-free work surface, as this will avoid damaging parts during assembly. The
shipping box provides an ideal work surface.
• Do not dispose of any packaging or contents of the shipping carton until assembly is
completed to avoid accidentally discarding small parts or hardware.
• Use the parts and hardware lists above to identify and separate each of the pieces
included.
• The illustrations provided allow for easier assembly when used in conjunction with
the assembly instructions.
• If using power tools to aid in assembly please use caution. Power tools can
damaged hardware or split wood.
• One extra drawer knob is included for your convenience.
TOOLS REQUIRED:
Phillips head screwdriver (not included)
PARTS INCLUDED:
(A) Feet – 4 pcs
(B) Wooden knobs – 6 pcs
(C) Flat head bolt – 6 pcs
ASSEMBLY INSTRUCTIONS:
1. Carefully turn the short dresser upside down.
2. Remove Feet (A) from inside the dresser drawer and insert them into the predrilled
holes in bottom of the dresser as shown.
3. Remove the Wooden knobs (B) from the drawer and them screw them into the
drawer front using the Pan Head Bolts (C) as shown. Turn all connections until tight.
4. Carefully bring piece upright.
CARE INSTRUCTIONS:
• Dust often using a clean, soft, dry lint-free cloth.
• Blot spills immediately, and wipe with a clean, damp, cloth.
• We do not recommend the use of chemical cleansers, abrasives, or furniture
polish on our lacquered finish.
Thank you for your purchase
stores | catalog | www.potterybarnkids.com
USA 1.800.290.8181
FURNITURE TIPPING RESTRAINT
Young children may be injured by tipping furniture. The use of a tipping restraint is highly recommended.
When properly installed, this restraint could provide protection against the unexpected tipping of furniture due
to small tremors, bumping or climbing. We recommend mounting this restraint to a wall stud.
WARNING: This product is only a deterrent. It is not a substitute for proper adult supervision.
Hardware Included:
(2) Brackets
(2) Long screws
(2) Short screws
(1) Nylon strap
INSTALLATION INSTRUCTIONS:
1. Locate a wall stud behind your furniture, Position a bracket on the stud approximately 1” below the
top of the furniture. Mark and drill pilot hole into the center of the stud with a 3/32” drill bit. Attach a
bracket to the stud with the long screws provided.
2. On the back of the furniture, a bracket will need to be attached to the furniture frame at the top. To
do this, temporarily move the furniture into its final position and mark the location of the wall bracket
on the furniture frame. Move the furniture away from the wall and place a bracket on the mark. Mark
and drill holes for screws with a 3/32” drill bit. Attach the bracket to the furniture with the short
screws provided.
3. Move the furniture into its final position, taking care to line up the wall bracket with the furniture
bracket. Thread strap through the bracket as shown in the illustration. Tighten strap until snug. Do
not over tighten.
Loading...