Pottery Barn Berkeley Drawer Chest Assembly Instruction

pottery barn kids

BERKELEY DRAWER CHEST

PRE-ASSEMBLY:

• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used
in conjunction with the assembly instructions.

• For your safety and ease, assembly by two adults is recommended.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use

care as some parts or hardware may have sharp points or edges.

• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.

P ARTS INCLUDED:
(A) Drawer Chest - 1pc
(B) Leg - 4pcs

TOOLS REQUIRED:
Phillips head screwdriver (not included)

ASSEMBLY INSTRUCTIONS:

1. Lay the Drawer Chest (A) down on a soft surface. Attach the Legs (B) to the Drawer Chest (A) as shown in
Figure 1.

(Fig. 1)

A

B

Page 1/3

2. Turn the Drawer Chest (A) upright. Pull out all the drawers. The wooden knobs are pre-attached at the back of
drawer fronts. Use Phillips head screwdriver (not included) to turn the screw counter clockwise until remove
knob from drawer front. Repeat until all Knobs are detached (see Fig. 2).

(Fig.2)

3. Fasten knobs to drawers using Phillips Head screwdriver, as shown in the figure below. Repeat until all knobs
are attached. (see Fig. 3).

(Fig.3)

Page 2/3