Pottery Barn Belden 2-Drawer Bed Assembly Instruction

pottery barn kids

BELDEN 2-DRAWER BED

PRE-ASSEMBLY:

• Read all instructions before beginning assembly . The illustrations provided allow for easier assembly when used
in conjunction with the assembly instructions.

• For your safety an d ease , asse mb ly by tw o adults is recommended.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work su rface. Use

care as some parts or hardware may have sharp points or edges.

• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.

PARTS INCLUDED:

(A) – Front Rail with 2 drawers - 1pc
(B) – Back Rail -1 pc
(C) – Side Rail - 2 pcs
(D) – Slat Roll - 1 pc

TOOLS REQUIRED:
Phillips Head Screwdriver (not included)

HARDWARE INCLUDED:
(E)– Large Phillips Head Screw 8x25mm (34 pcs)

B

C

D

A

C

Page 1/3

ASSEMBLY INTRUCTIONS:

1. Insert the Side Rail (C) into the hooks located on the end slots of the Fr ont Rail with 2 drawers (A). Push fir mly on
the top of the Side Rails (C) until they seat themselves over the pins inside the legs slots as shown. (Fig 1)

2. Repeat Step 1 with the Back rail (B). (Fig. 1)

3. Fix 2 Large Phillips head screws 8 x 25mm (E) to the wooden cleat of Side rail (C) as shown, tightening with a
Phillips Head Screwdriver. (Fig.2)

4. Tighten the levelers as shown. (Fig. 2)

Page 2/3

Fig. 1

E

Fig. 2

C