Pottery Barn Belden 1-Drawer Bed Assembly Instruction
pottery barn kids
BELDEN 1-DRAWER BED
PRE-ASSEMBLY:
• Read all instructions before beginning assembly . The illustrations provided allow for easier assembly when used
in conjunction with the assembly instructions.
• For your safety and ease, assembly by two adults is recommended.
• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work su rface. Use
care as some parts or hardware may have sharp points or edges.
• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.
• Use the parts and hardware lists to identify and separate each of the pieces included.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the
bolts to misalign during assembly.
• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.
.
PARTS INCLUDED:
(A) – Front Rail with 1 drawer (1pc)
(B) – Back Rail (1 pc)
(C) – Side Rail (2 pcs)
(D) – Slat Roll (1 pc)
(E) – Front Panel (1 pc)
TOOLS REQUIRED:
Phillips Head Screwdriver (not included)
HARDWARE INCLUDED:
(F) – Large Phillips Head Screw 8x25mm(34 pcs)
(G) – Small Mending Plate 70x40x3mm (2 pcs)
(H) – Phillips Head Screw 6x15mm (8 pcs)
Page 1/3
ASSEMBLY INSTRUCTIONS:
1. Insert the Side Rail (C) into the hooks located on the end slots of th e Front Rail with 1 drawer (A). Push firmly on
the top of the Side Rails (C) until they seat themselves over the pins inside the legs slots as shown. (Fig 1)
2. Repeat Step 1 with the Back rail (B). (Fig. 1)
3. Fix 2 Large Phillips head screws 8x25mm (F) to the wooden cleat of Side rail (C) as shown, tightening with a
Phillips Head Screwdriver. (Fig.2)
4. Attach the Small Mending Plates (G) to the Front panel (E) using the Phillips head screws 6x15mm (H),
tightening with a Phillips Head Screwdriver. (Fig.2)
5. Tighten the levelers as shown. (Fig.2)
Fig. 1
F
G
H
E
Page 2/3
Loading...