Pottery Barn Anderson Twin Bed Assembly Instruction

pottery barn kids

ANDERSON TWIN / FULL BED

IMPORTANT SAFETY INSTRUCTIONS:
Please read all instructions carefully before assembling.
For your safety, assembly by two adults is recommended.

PARTS INCLUDED:
(A) Headboard – 1pc

(B) Footboard – 1pc
(C) Side Rail – 2pcs
(D) Slat Roll – 1pc
(E) Finial – 4pcs
(F) Bun Foot – 4pcs

PRE-ASSEMBLY:

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work
surface, as this will avoid damaging any parts during assembly. The shipping box provides an ideal work
surface. Do not dispose of any contents until assembly is completed to avoid accidentally discarding
small parts or hardware.

• Use the parts and hardware lists above to identify and separate each of the pieces included.

• The illustrations provided allow for easier assembly when used in conjunction with the assembly

instructions.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may
cause the bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split
wood.

ASSEMBLY INSTRUCTIONS:

1. Determine the desired location of the bed. One person should hold the Headboard (A) in a vertical
position tilted slightly forward. Attach each Side Rail (C) to the Headboard (A) by inserting the hooked
ends of the Side Rail (C) into the corresponding slots in the Headboard (A), as shown. There are two
levels for the Side Rails (C). If you plan on using a trundle, please use the highest setting. Be sure the
small ledge on each Side Rail (C) is facing inward. Repeat with Footboard (B).

HARDWARE INCLUDED:
(G) Screw 4 x 30mm

TOOLS REQUIRED:
Phillips Head Screwdriver

– 28pcs

A.

C.

C.

B.

2. Place the Slat Roll (D) on the small ledges of the Side Rails and loosely secure with 28 Screws (G) using
a Phillips Head Screwdriver, as shown. Once all Screws (G) are in place, fully tighten.

G.

D.

3. Thread the Finials (E) and Bun Feet (F) into the inserted nuts located on posts of the Headboard (A) and
Footboard (B).

E.

E.

E.

F.

E.

E.

F.

E.

F.

F.

F.

CARE INSTRUCTIONS:

• Dust with a clean, soft cloth.

• Bolt spills immediately, and wipe with a clean, damp, cloth.

• We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered

finish.

Thank you for your purchase.

stores | catalog | www.potterybarnkids.com

USA 1.800.290.8181