Pottery Barn Anderson Trundle Assembly Instruction

pottery barn kids

ANDERSON TRUNDLE

PRE-ASSEMBLY:

• For your safety and ease, assembly by two adults is recommended.

• Please read all instructions before beginning assembly. The illustrations provided allow for easier assembly

when used in conjunction with the assembly instructions.

• Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface. The shipping
box provides and ideal work surface. Do not dispose o f any con te nts unti l assembly is completed to avoid
accidentally discarding small parts or hardware.

• Use the parts and ha rdware lists to identify and separate each of the pieces included prior to starting
assembly.

• Note: DO not fully tighten the bolts until all parts are in place. Failure to follow these instructions may cause
the bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood.

PARTS INCLUDED:
(A) Left and Right Board (with ex tra holes)– 2pcs

(B) Center Bottom Board – 1pc
(C) Cross Bar – 2pcs
(D) Long Side Rail – 1pc
(E) Long Side Rail with Deco r – 1pc
(F) Short Side Rail – 2pcs

D

F

F

TOOLS REQUIRED:
Philips Screwdriver (Not included)

HARDWARE INCLUDED:

(G) Long Wood Screw 4 x 30mm

– 22pcs

(J) Allen Bolt ¼” x 60mm – 8pcs

(M) Caster – 6pcs

A

B

A

C

C

(H) Barrel Nut – 8pcs

(K) Spring Washer – 4pcs

(N) Short Wood Screw 4 x 13mm

– 24pcs

Page 1/4

E

(I) Allen Key – 1pc

(L) Flat Washer – 4pcs

ASSEMBLY INSTRUCTIONS :

1. Lay the Left and Right Bottom Boards (A) on either side of the Center Bottom Board (B) with the pre-drilled

holes facing up, as shown in Figure 1. Attach (2) Cross Bars (C) to the bottom boards by inserting (12)
Long Wood Screws (G) into the pre-drilled holes of ea ch cross b ar, tig hteni ng wit h the Philips Scre wdriv er.

Figure 1

G

A.

B.

A.

2. Turn assembled base upside down. Insert the wooden dowels on the ends of the Cross Bars (C) into the

pre-drilled holes on the Long Side Rails (D & E), as shown in Figure 2. Press firmly to ensure the Left
and Right Bottom Boards (A) sit in the slots of the Long Side Rails (D & E).

Figure 2

D

A

B

A

E

Page 2/4