This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions manual, may cause
interference to radio communications. It has been tested and found to comply with
limits for a Class A digital device pursuant to subpart J of Part 15 of FCC Rules, which
are designed to provide reasonable protection against interference when operated in a
commercial environment. Operation of this equipment in a residential area is likely to
cause interference in which case the user at his own expense will be required to take
whatever measures to correct the interference.
Warranty Limits:
Warranty terminates automatically when any person other than the authorized
technicians opens the machine. The user should consult his/her dealer for the problem
happened. Warranty voids if the user does not follow the instructions in application of
this merchandise. The manufacturer is by no means responsible for any damage or
hazard caused by improper application.
Rugged design with reinforced heavy gauge steel construction
Large ball bearings riding on special guides for remarkably smooth
drawer slide
Contemporary style
Advanced electronics that extend the MTBF (Mean Time Between
Failure)
Precision mechanical parts with tight tolerance to assure wobble-free
drawer movements
Check slot for non-cash or large-bill transaction
Three-position lock for maximum cash security
Drawer open sensor
USB Interface with power adaptor for CR-3105 and CR-3015 is USB
power driven without power adaptor.
Removable tray with a lock-on cover. Bill compartments and coin
compartments are adjustable. The tray cover TC2100 for CR3105 is
optional.
CARTON CONTENTS
1. Cash drawer pre-assembled.
2. User’s manual.
3. Key 2pcs: There is a key serial No. sticker on the cash drawer bottom
plate. If user lost the key he/she can order the key according to this
number.
4. Signal Cable: USB cable is already built on.
5. Power Source: Power adapter 12VAC 1.5A for CR-3105
INSTALLATION
1). Use the attached key to open the cash
drawer and pull it wide open. Pick up
the cash tray inside the drawer frame
from the front edge and take the tray
out. The space inside the drawer
frame and under the cash tray will be
the room for the checks / large
amount bills inserted through the
check slot in normal operation. Insert
the bill compartment separators and
coin compartment separators from the
accessory bag into the tray bottom in
Page 2
suitable pitch according to domestic bill sizes. Insert the bill clips into
the rear end of each section set by the bill compartment separators. Be
sure to insert the separators and the clips till it clicks in position. For
OEM models with fixed partitions, the separator and clip insertion can
be omitted.
2). Define a drawer number for the cash drawer so that this cash drawer is
going to respond accordingly in USB communication. Follow the table
below for “Switch settings” to adjust the switch S1 according to this
drawer number if it is not 7. Please note that within each system there
should never be any 2 USB interface cash drawers carrying the same
drawer number.
Rear View of Model CR-3105 / CR-3015
Cash Drawer with USB Interface
For CR-3015 there is no AC power input
in back panel.
0 1 2 3 4 5 6
ON OFF ON OFF ON OFF ON
ON ON OFF OFF ON ON OFF
ON ON ON ON OFF OFF OFF
Reserved
7
OFF
OFF
OFF
3). Connect USB connector of cable coming out from the rear side of the
USB interface cash drawer to USB port of main PC.
4). For CR-3105 Check the specification of power adaptor on its nameplate.
Insert the power adaptor into the correct power outlet. Insert the output
plug to the jack at rear side of CR-3105 to supply power for drawer
kickout. For CR-3015 there is no power adaptor needed. The power
source drain from USB directly.
5). Install the USB utility driver from Posiflex Product Information CD
with Posiflex POS system or visit our web sites
http://www.posiflex.com
or http://www.posiflex.com.tw or
http://www.posiflexusa.com for latest updates.
Page 3
UPOS driver application
Please first find in Posiflex Product Information CDROM or
download from Posiflex web sites for UPOS driver setup. In this application,
CR-3105/3015 is compliant to UPOS version 1.8.
SPECIFICATIONS
MECHANICAL: Dimensions:
400 (W) x 410 (D) x 85 (H) mm
Weight: 6.7 Kg
Removable tray with a lock-on cover (option)
ELECTRICAL:
Power Source (For CR-3105 only)
AC Adaptor
Input Voltage 120 VAC ± 10 % / 240 VAC ± 10 % @50 -60 Hz
Output Voltage 12 VAC at 1.5 A
Interface
USB (1.1)
Security Code
USB PID (as defined by switch settings)
Drawer Open Sense
Through USB driver
KEYLOCK OPERATION
Keylock
Lock ( ): Physically lock the drawer.
Open ( ): Open the drawer by the key.
Standby ( ): Automatically open the drawer by USB
interface command control
STRUCTURE
Caution: For CR-3015, the drawer kick out duty cycle
should not less then 15 seconds, otherwise it may not kick
the drawer.