Polk CSI-25 Owners manual
AKING CARE OF YOUR CS
T
i SERIES LOUDSPEAKER
Your new CSi Series Loudspeaker are constructed of a rugged material that can be dusted or cleaned with a damp cloth.
Avoid harsh detergents and cleaning fluids, as they can permanently damage your speakers’ finish
[figure 4]. Vacuum
the grilles to remove dust.
FIGURE 4
Do not use furniture polish on veneer.
Clean veneer with a damp cloth.
Cuidado del acabado de madera natural.
FIGURE 4
Entretien de la finition en bois véritable.
Pflege der Holzappretur.
PRODUCT
SPECIFICATIONS
i25
CS
DRIVER COMPLEMENT:
2 - 5 1/4"(133mm) drivers
3/4"(19mm) tweeter
OVERALL
FREQUENCY RESPONSE:
55Hz-22kHz
-3DB LIMITS:
60Hz-20kHz
RECOMMENDED
AMPLIFICATION
10-100 watts/channel
EFFICIENCY (1M,1W):
90dB
IMPEDANCE:
Nominal 4 Ohms
Compatible with 8ohm outputs
CROSSOVER FREQUENCY:
2.3kHz
CROSSOVER SLOPE:
2nd Order HP,
2nd Order LP
ENCLOSURE TYPE:
Ported
DIMENSIONS:
6.5" H x 19" W x 8" D
(165mm H x 483mm W x 203mm D)
SHIPPING WEIGHT:
20 lbs. (9.1kg.)
:
LIMITED FIVE YEAR W
ARRANTY
Polk Audio, Inc. warrants to the original purchaser only that this Polk Audio Loudspeaker Product (the “Product”) will be free from
defects in materials and workmanship for a period of five (5) years from the date of original retail purchase from a Polk Audio
Authorized Dealer. However, this Warranty will automatically terminate prior to the expiration of the five (5) years if the original
retail purchaser sells or otherwise transfers the Product to any other party. The original retail purchaser shall hereinafter be
referred to as “you.” To allow Polk Audio to offer the best possible warranty service, please fill out the Product Registration
Card(s) and send it to the Factory, at the address provided on the Product Cards(s) within ten (10) days of the date of purchase.
Defective Products must be shipped, together with proof of purchase, prepaid insured to the Polk Audio Authorized Dealer from
whom you purchased the Product, or to the Factory at 2550 Britannia Boulevard, Suite D, San Diego, California 92154. Products
must be shipped in the original shipping container or its equivalent; in any case the risk of loss or damage in transit is to be borne
by you. If upon examination at the Factory or Polk Audio Authorized Dealer it is determined that the unit was defective in materials
or workmanship at any time during this Warranty period, Polk Audio or the Polk Audio Authorized Dealer will, at its option, repair or
replace this Product at no additional charge, except as set forth below. All replaced parts and Products become the property of
Polk Audio. Products replaced or repaired under this warranty will be returned to you, within a reasonable time, freight prepaid.
This warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence,
inadequate packing or shipping procedures, commercial use, voltage inputs in excess of the rated maximum of the unit, cosmetic
appearance of cabinetry not directly attributable to defect in materials or workmanship, or service, repair, or modification of the
Product which has not been authorized or approved by Polk Audio. This warranty shall terminate if the Serial number on the
Product has been removed, tampered with or defaced.
This warranty is in lieu of all other expressed Warranties. If this Product is defective in materials or workmanship as warranted
above, your sole remedy shall be repair or replacement as provided above. In no event will Polk Audio, Inc. be liable to you for any
incidental or consequential damages arising out of the use or inability to use the Pr
oduct, even if Polk Audio, Inc. or a Polk Audio
Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other party. Some states do not
allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you.
All implied warranties on this Product are limited to the duration of this expressed Warranty. Some states do not allow limitation on
ranty lasts, so the above limitations may not apply to you. This Warranty gives you specific legal rights,
how long an implied W
ar
and you also may have other rights which vary from state to state.
This Warranty applies only to Products purchased in the United States of America, its possessions, and U.S. and NATO armed
forces exchanges and audio clubs. The Warranty terms and conditions applicable to Products purchased in other countries are
available fr
om the Polk Audio Authorized Distributors in such countries.
CSi25
Center Channel Loudspeaker
Owner’s
Manual
RM2515-1
POLK AUDIO, INC. • 5601 METRO DRIVE, BALTIMORE, MD 21215 USA
800.377.7655 • SALES DEPT. FAX: 410.358.2870
.POLKAUDIO.COM
WWW
POLK AUDIO HISTORY—A PASSION FOR SOUND
Polk Audio was founded in Baltimore in 1972 by Johns Hopkins University graduates Matthew Polk and George Klopfer.
Today, Polk Audio is a leading international manufacturer of high quality home, car and multimedia loudspeakers. Polk
products emphasize superior sound and build quality, and feature many patented and award-winning innovations. Polk
Audio has built a reputation as “The Speaker Specialists.” Polk products are sold throughout the USA, Canada and in
over 50 countries around the world. Polk Audio’s mission has always been to build high quality, great sounding
speakers at affordable prices. For the people of Polk Audio, building speakers is not just a job; it’s a
passion.
FIGURE 1
OR
FIGURE 1
Most popular placement, above the TV screen. CSi Series Center Speakers are magnetically shielded for safe
placement near TV or video monitors. If you notice video distortion or discoloration, immediately move the
speakers away from the video source and call Polk Audio Customer Service 800.377.7655 (US and Canada)
or polkcs@polkaudio.com.
La ubicación más común es encima de la pantalla del televisor. Los altavoces centrales de la serie
CSi tienen blindaje magnético para poder ubicarlos con seguridad cerca de monitores de televisión
o de video. Si nota que hay distorsión o descoloración de la imagen, aleje inmediatamente los
altavoces de la fuente de video y comuníquese con el servicio al cliente de Polk Audio.
Disposition la plus courante, au-dessus de l’écran. Les enceintes de la série CSi sont blindées
magnétiquement et peuvent être disposées à proximité d’une télé ou d’un moniteur vidéo.
Si vous percevez de la distorsion ou de la décoloration vidéo, éloignez immédiatement les
enceintes de l’écran et communiquez avec le ser
Häufigste Platzierung – über dem Fernsehbildschirm. CSi-Mittenlautsprecher sind für eine Platzierung in der Nähe
von Fer
nsehgeräten oder Videomonitoren magnetisch abgeschirmt. Wenn Sie eine Verzerrung oder Verfärbung des
Videobildes bemerken, sind die Lautsprecher umgehend von der Videoquelle zu entfernen. Setzen Sie sich in diesem
Fall mit dem Kundendienst von Polk Audio in Verbindung.
vice à la clientèle de Polk.
SAFE LIMITS OF
OPERATION
Your Polk loudspeakers are made with the
highest quality materials for years of trouble-free performance.
However, damage to
loudspeakers can
occur when an amplifier, regardless of its
wattage, is made to
play at higher listening
levels than its power
can clearly produce
(usually beyond the “1
to 2 o’clock” position
on the volume control). This results in
very high levels of
audible distortion,
originating in the amp-
, that can add a
lifier
harsh, gritty sound to
music. Contrary to
popular belief, a
speaker is more likely
to be damaged by tr
y
ing to get too much
volume from a low-
ed amp or
power
receiver than from a
high powered one.
PLACEMENT RECOMMENDA
FOR THE CS
i SERIES CENTER CHANNEL LOUDSPEAKER
The CSi Series Center Channel Loudspeaker incorporates the most effective magnetic shielding available so it can be
placed safely on or near your TV or video monitor. If you notice video distortion or discoloration, immediately move the
speaker away from the TV and call Polk Audio Customer Service 800-377-7655 (9
polkcs@polkaudio.com. The most popular placement for a center channel speaker is on top of your TV, anchoring the
dialogue and effects to the screen
using a front projection TV system, place the center channel speaker on a small stand or table immediately below the
TIONS
AM to 6PM EST, US or Canada) or
[figure 1]. An alternate placement is on a shelf below your TV [figure 1]. If you are
FIGURE 2
FIGURE 2
Basic Center Channel Speaker hookup diagram.
Set Center Channel to “small” in your receiver’s
Bass Management settings.
Diagrama básico de conexión.
Diagramme de branchement rudimentaire.
Gr
undlegendes Anschlussdiagramm.
bottom of the projection screen, or at ear level behind the screen if your screen is acoustically transparent. Consult the
owner’s manual for your screen. Adhesive rubber feet are included with your CS
i Center Channel Loudspeaker and may
be attached to the bottom of the speaker to protect your furniture and keep the speaker in place.
PROCESSOR MODE CONFIGURATION
FOR THE CS
The “bass management” or “speaker configuration” menus of most surround receivers offer the choice of “normal” or
“wide” modes for center channel operation. In discrete channel digital processors these modes are referred to as
“small” and “large.” Normal (small) mode filters bass frequencies from the center channel speaker and sends them
instead to the front left & right main speakers or to the subwoofer output (LFE) jack. Wide (large) mode sends an
unfiltered, full range signal to the center channel speaker. Use the Small (normal) mode for optimum center (and
surround) channel performance and reliability.
CONNECTING YOUR CSi SERIES LOUDSPEAKER
[FIGURE 2]
e recommend 16-gauge or larger speaker wire. Follow the hookup directions included with your receiver. Strip 1/2 inch
W
(12.7mm) of insulation from each of the two conductors of the wire to expose the bare metal and twist each of the
individual conductors into single unfrayed strands. Note that one of the terminals on the rear of each speaker is red (+)
and the other is black (-). Make certain that you connect the wire from the red (+) terminal of your amplifier or receiver to
the red (+) terminal on your speaker and the wire from the black (-) terminal of your amplifier or receiver to the black (-)
i SERIES CENTER CHANNEL LOUDSPEAKER
FIGURE 3
Loosen hex nut
Desenr
tuerca hexagonal
Desser
Sechskantmutter lösen
osque par
rer l’écrou
cialmente la
Insert speaker wire
thr
ough hole
Inser
la bocina en el orificio
Insér
dans le trou
Lautsprecher-Draht durch
das Loch schieben
e para
te el alambr
er le fil du haut-parleur
ighten hex nut
T
osque la tuer
Enr
Serrer l’écrou
Sechskantmutter festschrauben
ca de nuevo
t insulated
Do not inser
section of speaker wir
No inserte alambre con
material aislante
Ne pas insérer la partie
isolée du fil du haut-parleur
Isolation des LautsprecherDrahtes nicht in das Loch schieben
e
FIGURE 3
Using binding post connections.
Uso de conexiones con tornillos de presión.
Utilisation des bornes de branchement.
Verwendung von Anschlussklemmen.
To use Banana Plugs (US only):
Unscrew the binding post lug nuts completely
to expose the binding post plugs
(plastic plugs inserted into the binding posts).
Car
Screw the lug nuts back on the binding posts
y out the binding post plugs
efully pr
to expose banana plug holes.
t banana plugs.
and inser
(This is for US owners only
.)
terminal on your speaker. Most wire has some indicator (such as color-coding, ribbing or writing) on one of the two
conductors to help you maintain consistency.
To connect wire to the binding post
of the binding post. Do not inser
-
Twist the hex nut back down the binding post until it firmly meets the wire. Do not over tighten.
[figure 3], unscrew the hex nut and insert the bare wire into the hole near the base
t the insulated part of the wire into the hole as this will not give you a good connection.
To use Banana Plugs (US only): Unscrew the binding post lug nuts completely to expose the binding post plugs
(plastic plugs inserted into the binding posts). Carefully pry out the binding post plugs to expose banana plug holes.
Screw the lug nuts back on the binding posts and insert banana plugs. (This is for US owners only.)
FOR MANUAL UPDATES, VISIT
http://www.polkaudio.com/home/products/center/csi
FOR MORE DETAILED HOOK UP AND PLACEMENT INFORMATION, VISIT
http://www
FOR RECOMMENDED ACCESSORIES (INCLUDING SPEAKER STANDS, BRACKETS
AND EXCLUSIVE POLK AUDIO LOGOWEAR), VISIT OUR WEBSTORE:
http://shop.polkaudio.com/
.polkaudio.com/home/faqad/
Contact Polk Audio Customer Ser
vice 1-800-377-7655 (Outside US: 410-358-3600), polkcs@polkaudio.com
for mor
mation visit our website at www.polkaudio.com
e infor
Loading...