Polaroid Polaview 1700, Polaview 1900 Quick Reference Guide
MON (monitor)
LCD
CPU
(computer/VGA)
Polaview 1700/1900
Quick reference guide
Thank you for purchasing Polaroid’s liquid-crystal-display
(LCD) projection panel. This quick-setup information is
common to both the Polaview Model 1700 and Model 1900
Projection Panels, except where indicated.
Quick setup
procedures
1 Turn off your computer system and overhead projector.
Place your panel on the overhead projector.
2 Connect the video Y-cable as shown below for either
VGA or Macintosh II systems. VGA systems use cable part
number C454-6, Macintosh II systems use cable part number C464-6.
3 Power: With your panel POWER switch in the Off position,
connect the AC adapter to the panel power connector, then
plug the power cord into the adapter. Finally, plug the
power cord into a grounded AC wall outlet.
4 Turn on your panel first, then the computer, monitor, and
finally the overhead projector.
2 Quick reference guide
Video In*
Audio In*
Audio Out*
S-VHS In*
Cyclops
connector
Computer
video port
Serial port
Power port
*Model 1900 only
Power
– Intensity +
Freeze
Clear
Sync Store Rear Proj
Colors Rev Vid Status– Contrast +
Shift
Text Vid Sel
– Volume +
R Tint G
On
Model 1900 only
9876
5
4
3
21
For video connections
(Model 1900 only)
For audio connections
(Model 1900 only,
cables not included)
Control panel
Cable part number C400-6 connects the video-source
Video Out jack to the Video In jack of your panel. Cable
part number C466-6 (not included) connects an S-VHS or
S-Video source to the S-VHS input port of your panel.
Connect the audio-source Audio Out jack to the
Audio In jack of your panel. Connect your panel
Audio Out jack to the optional loudspeaker system
(part number A55) or other audio source.
Un-SHIFTed keys
Un-SHIFTed key functions are printed in black on the
panel. For the Model 1700, the VID SEL key is printed
in red and is functional only when the external video
adapter (part number A194) is installed.
Loading...