Polaroid PLCHUSY Instructions Manual

INSTRUCTIONS

UNIVERSAL CHARGER FOR LI-ION BATTERIES

SONY

PLCHUSY

BG1
BN1
BK1
BD1
FW50
BTSE10
FH50

FH70
FH100
FV50
FV70
FV90
FV100

SONY BATTERY LIST

PRECAUTIONARY INFORMATION

Locate your battery type from the list provided. If your type is
not listed, DO NOT USE THIS CHARGER. Improper use can
cause the charging circuit to burn out, and batteries not listed
may over-heat and may combust. Do not use the charger in
wet locations.

CHARGING INSTRUCTIONS

1 Insert your choice of power adapter cords into the jack

provided on the rear of the charger, either the 2-prong
120-volt adapter or the 12-volt automotive cigarette
lighter plug.

2 The green LED power indicator will light.
3 Locate your battery’s model number in figure A and insert

it into that slot. Be sure the battery contacts align with the
charging terminals in the slot.

4 The LED will turn red during charging and will return to
green when the charging cycle is complete (30-60 minutes
depending on battery size and voltage rating).

5 When the LED returns to green, remove the battery from its
charging slot and disconnect the adapter cord from its
power source.

Questions?
Need some help?

For technical support
please call 1-800-226-6534
or visit www.polaroid.com

Distributed by: C&A Licensing, LLC 2 Bergen Turnpike, Ridgefield Park, NJ 07660

Polaroid and Polaroid & Pixel are trademarks of PLR IP Holdings, LLC, used under license. All other
trademarks are the property of the respective owner, who has not sponsored, endorsed or approved this
product. PLR IP Holdings, LLC does not manufacture this product or provide any Manufacturer’s Warranty
or support. For warranty information, visit www.polaroid.com.

© 2011 All Rights Reserved