Polaroid PDR400 Instruction Manual
Digital Voice Recorder
PDR400
Instruction Manual
MENU
REC/STOP
MENU
REC/STOP
3
4
5
6
7
8
9
10
19
11
12
13
14
15
16
17
18
19
1
2
GETTING STARTED
Location of controls
1. Microphone jack 6. Micro SD slot 11. Stereo Mic. right 16. VOL +
2. Earphone jack 7. PLAY / PAUSE
12. HOLD switch 17. FOLDER
3. Stereo Mic. left 8. PRE
13. LCD screen 18. REC / STOP
4. Recording indicator 9. VOL - 14. REPEAT 19. Battery
5. USB jack 10. MENU
15. FWD compartment
GETTING STARTED
Installing the Batteries
1. Remove the battery cover on the back of the unit.
2. Install two (2) R03/AAA batteries (not included).*
3. Replace the battery cover.
4. Battery indications shown on the LCD screen:
• Batteries are fresh:
• Batteries are week or expired (replace batteries):
* Notes: Make sure the polarity (+/-) of the batteries matches the marks inside the battery
compartment. Do not mix old and new batteries, carbon and alkaline. Remove batteries
when the product is not in use for extended periods of time.
Power ON
• Press and hold PLAY until the red indicator light blinks to turn on the unit.
Power OFF
1. Press and hold PLAY until the LCD screen goes off to power OFF the unit
2. The unit will also power OFF automatically if left idle for sixty (60) seconds without
pressing any button.
GETTING STARTED
Hold Function
• To disable the controls, slide the HOLD switch and the word “HOLD” and the icon will
flash briefly on the LCD screen.
• To disable the Hold function, slide the HOLD switch and the
icon disappears.
• All buttons will return to their normal function .
Setting the Backlight
1. Press and hold for three (3) seconds to enter the menu.
2. Press
or until “Backlight” is highlighted.
3. Press
to enter.
4. Press VOL+ or VOL - to adjust the backlight time.
5. Press
or press to return to the menu.
Setting the Contrast
1. Press and hold for three (3) seconds to enter the menu.
2. Press
or until “Contrast” is highlighted.
3. Press
to enter.
4. Press VOL+ or VOL - to adjust the contrast level.
5. Press
or press to return to the menu.
Setting the Language
1. Press and hold for three (3) seconds to enter the menu.
2. Repeatedly press
or until “Language” is highlighted.
3. Press
to enter.
4. Press
or to choose a language.
5. Press
or press to return to the menu.
Setting the Key Tone
1. Press and hold for three (3) seconds to enter the menu.
2. Repeatedly press
or until “Key Tone” is highlighted.
3. Press
to enter.
4. Press VOL+ or VOL - to adjust the Key Tone level.
5. Press
or press to return to the menu.
Loading...