Pogo RipFlash DX 256MB, RipFlash DX User Manual

Table of contents

Preparations

Preparations ––

Basic operation

Basic operation--

Additional operation

Additional operation --

CD-Ripping
Delete
Encoding function
Recording the voice

--Connection to computer

Connection to computer --

Installing Manager software
Deleting Manager software
Connecting to computer
Downloading files to DMR-300
Uploading files
Deleting files
Formatting the memory

--Moodlogic

Moodlogic

Installation

Installation --

--Appendix

Appendix --

System requirements
Trouble shooting
Specification

WARNING



DANGEROUS VOLTAGE

Uninsulated Dangerous Voltage, that may be of
sufficient magnitude to constitute a risk of electric
shock to person is present within this product’s
enclosure.

!

ATTENTION

The owner’s manual contains important operating and maintenance
instructions. For your safety, it is necessary to refer to the manual.

To reduce the risk of fire or electric shock, do not expose this appliance
to rain or moisture.
To avoid electrical shock; do not open the case. Refer servicing to
qualified personnel.

CAUTION : Use of the controls or adjustments of procedure other than
those specific herein may result in hazardous radiation.

Do not operate the unit during the driving, bicycling or operating other
machine.
Do not insert metal with the batteries. (risk of fire)
It is recommended that you follow the listed guide line to prevent damage of
hearing.
Establish a safe sound level.

► Slowly increase the level of volume until you can hear comfortably.
► Once you have established a comfortable listening level, DO NOT

INCREASE THE SOUND LEVEL FURTHER.

(Over 80dB noise can be harmful under constant exposure. 80dB: average

city traffic, alarm clock buzzer at two feet)

Do not drop or give mechanical shock to the unit.
Do not place the unit in locations described below :

► Places exposed to direct sunlight, extreme heat or magnetized places
► Humid or moist places
► No ventilation or dust places

Do not clean it with thinner, alcohol or benzene.

WARNING

Components

Software

installation CD

Stereo Ear

phone

Remote

control

USB cable

2 AAA Size

batteries

Line in cable Carrying

bag

Necklace

Using buttons and controls

LCD

Neck strap holder

MIC

MENU

Record

Local Repeat

HOLD Switch

VOLUME

Line-IN

Earphone jack

FORWARD

REVERSE

POWER ON/OFF
PLAY/PAUSE/STOP

Record (Voice/Music)Mode MENU

Local repeatHold switch

Play the previous track

/ Rewind the current track

Volume

Play the next track
/ Fast forward in the current track

Power On / Play / Pause / Stop /
Power Off

Hold icon

Play icon

Pause icon

Music recording icon

Voice recording icon

Local repeat icon

Play mode icon

MMC / SD card icon
This icon will blink while the song in

MMC or SD card is played.

Volume level

Remaining battery capacity

MMC & SD card slot
/ USB jack

< Rear >

Inserting Battery

① Slide open the cover as shown
in the figure.
②Insert 2 AAA alkaline batteries
(supplied). Slide the cover back to
close.
③ Use the alkaline batteries.

Note

If you do not use the batteries
correctly, it may become damaged.
Be sure to check the polarity of the
batteries (+,-), while inserting the
batteries.

13 hours2 alkaline batteries

MP3Battery lifetime

The bars inside a battery icon displays
the remaining battery capacity.

The icon will blink when the batteries
have almost run out. This unit will be
automatically powered off in 30
minutes from this time.

Adding MMC / SD card

If you need additional memory, you can purchase the MMC (the Multi Media
Card) or SD card(Secure Digital memory card) as shown in the figure.

② Turn on the unit to display the
memory capacity of the MMC or SD
card on the LCD.

Eject MMC / SD card,

① Press the MMC / SD card in the
direction of the arrow.

② MMC / SD card will pop up.
③ Pull out the MMC / SD card.

Note

- Be sure to turn off this unit when you
insert or eject the MMC / SD card.

- Format the memory data to down load
the MP3 file.(32page)

- Downloading to the MMC or SD card is
the same as downloading to internal
memory.(28page)

① Align the MMC or SD card with the
slot as shown in the figure and insert it
to the end.

Playing songs on “RipFlash DX”

① Insert the batteries and connect
the earphones to the player.

② Press to turn on.
③ Press again to play a song.

< stop / turn off>

① Press and hold for 3 seconds
to stop.
② When stopped, press and hold
for 3 seconds to turn off.
The unit automatically turns off 5
minutes after it stops playing.
③ When stopped, press to play.

< Pause >

① Press to pause while playing.
② When paused, press to play.

< Playing / turn on >

Selecting the track / Volume control

………………………………………………………………………………

the current track.

playing MP3 files of 64kbps or less.

Press +/- button to adjust the volume
while playing.
Press +/- button to adjust step by
step.
Volume range from 0 to 30.
Press and hold +/- button to adjust
continuously.

the current track.

Using the Remote Control

☼ note :

Under hold mode, no buttons on the
remote control will work. You can
adjust the volume while playing.

Press  to skip to the next track.
Press and hold  to fast forward

the current track.



① Press and hold ▶ ▍▍ to turn on
the player.

② Press ▶ ▍▍ to play.
③ Press ▶ ▍▍ to pause.

▶ ▍▍

press Ⓜ to change REPEAT mode,
from NORMAL REPEAT→REPEAT
ONE→REPEAT
ALL→RANDOM PLAY→RANDOM ALL.

Press █ to stop the playing.
Press and hold █ to turn off.

Press  to locate the beginning
of the track or the previous track.

Press and hold  to rewind the
current track.

Ⓜ

█



Volume

HOLD

Forward

Play / Paused

Rewind

Stop

Menu

Hold function / Local Repeat

Hold mode

Local Repeat mode

To repeat a part of the current track,

① Press to start the local recording.

② Press to finish the local recording.

③ Repeat the recorded part.

④ Press to finish the local repeat and

play the current track.