Pocketbook Pro 902 Firmware Upgrade Instruction

Error message

Reason

Repair

No update image found

File SWUPDATE.BIN is not found at
the SD card.

Try to format the SD card (previously saving
all the information on your hard drive) and
copy firmware update file to the formatted
card. In case the error is repeated, try to
upgrade using another SD card.

Update image is

SWUPDATE.BIN file is corrupted or

Delete unnecessary files from the card and

Quick Firmware Installation Guide

Model РВ 902

WARNING! Firmware Update - important operation, during which control program
of e-book will be changed. In case of improper execution, control program may be
damaged, causing loss of device efficiency and referring to the service center. Try
to perform the upgrade procedure strictly following the instructions.

To update the device software you can download new firmware from our

website: www.pocketbook-int.com.

Select your location, the model of your device in the Products section, click
the right software and documentation link to enter the section of the software
update.

Download to PC the latest firmware from the firmware section.

Then you can install the firmware on the device, follow these steps:

1. Unpack the archive content at external micro SD card or root folder of the

internal memory.

2. Turn off PocketBook Pro pressing the "On / Off".

3. Turn on PocketBook Pro by pressing the "On / Off";

4. While the device is turning on, press and hold buttons: paging "Back" and

paging "Next" until the message «Firmware update ...» is appeared;

5. Attention! Follow the instructions on the screen.

Note: The device can be reloaded during update process;

6. When the inscription «Update is OK. Now please reset device» appears

on the screen, switch on the device, the firmware installation is completed.

Note: The firmware version can be checked in "Settings»⇨ «Device
Information".
Note: If the firmware file is located in the root folder of your device, it has a higher

priority for the upgrade procedure than the file which is located at the SD card.

Troubleshooting

corrupted

or Image is empty

there is no space at the SD card.

copy the file SWUPDATE.BIN again. Try to
download the firmware from the site

www.pocketbook-int.com. In case the error is

repeated, try to upgrade using another SD
card.

File reading error

SD card reading error

Try to upgrade firmware using another SD

card.

Error: The device is
installed another
version of the
firmware.

One of the requirements of the
firmware installing program was not
implemented. See p 5. The
firmware installing was interrupted
by timeout.

Remove the old firmware file from the

root of internal memory.

After checking, it was
found that the
firmware version of the
device has not been
updated.

One of the requirements of the
firmware installing program was not
implemented. See p 5. The
firmware installing was interrupted
by timeout.

Start installing the firmware again, and
carefully and on time, follow the
instructions of the program. For example:
"Plug in" and "Press the center button"