Plinius 9100 Brochure

THE HEART OF MUSIC

9100

INTEGRATED
AMPLIFIER

9100

INTEGRATED
AMPLIFIER

To own a separate control and power amplifier is the dream of
many music enthusiasts. Imagine having that level of performance
in a single box. The design team responsible for the PLINIUS
Odeon have forged and moulded a chassis system of function
and beauty from the very best materials and this heritage
guarantees performance and long term reliability.

Function should come before frills and the 9100 exemplifies this
notion. It is a purpose built design where each material or
component choice has been made, always aiming for the
maximum possible performance.

Power is an important part of this amplifier’s character and with
a generous 120 Watts per Channel the 9100 should satisfy even
the most demanding applications. In fact you may never approach
the maximum output of the 9100 but if required there is comfort
in the fact that it is there and available. The circuit of the 9100
is based on the PLINIUS Odeon Amplifier Development and
shares the much praised PLINIUS House sound.

The 9100 is a specialist amplifier ready to combine with the
abilities of a new generation of components from specialists
around the world. It will prove revealing of any improvements
made at source in a system and has the ability to drive any
worthwhile speakers with authority and finesse.

Although designed primarily for high quality reproduction of
music, the 9100 will enhance the performance of both home
theatre and multi-room systems by virtue of its flexible design.

Specifications For Plinius 9100

Power:

120 watts per channel into 8 Ohms
Both channels driven from 20Hz to

20kHz at less than 0.2% total
harmonic distortion

Frequency Response:

20Hz to 20kHz +/–0.2dB
–3dB at 5Hz and –3dB at 70kHz

Distortion:

Typically <0.05% THD at rated power

0.2% THD and IM worst case prior
to clipping

Current Output:

20A short duration peak per channel
Fuse protected

Slewing:

50V/µs.

Hum & Noise:

90dB below rated ouput 20Hz to
20kHz unweighted

Gain:

Line inputs to speaker out: 40dB

Input Impedance:

47kOhms all inputs

Input Overload:

5V RMS

Rated Pre Out Level:

1.5V RMS into 47kOhms or higher

Pre Out Source Impedance:

Typically 1.5k Ohms

Pre Out Minimum
Recommended Load:

47k Ohms

Tape Output Level:

190mV at 200 Ohms
Tape loop muting at 5V RMS input

Dimensions:

Height: 105mm (4”)
Width: 450mm (17 3/4”)
Depth: 400mm (15 3/4”)
Weight: 10kg (22lbs)

Plinius Audio Limited
PO Box 1836, Palmerston North
New Zealand

Ph [phone]
Fax [phone]
Email [e-mail]

www.pliniusaudio.com