Plantronics VOYAGER 510S User Manual

WARRANTY, SERVICE, AND SUPPORT INFORMATION

IMPORTANT SAFETY INFORMATION

LIMITED WARRANTY

For Plantronics Non-commercial Products Purchased in the US & Canada

• This warranty covers defects in materials and workmanship of Non-commercial
Products manufactured, sold or certified by Plantronics which were purchased
and used in the United States and Canada.

• This warranty lasts for one year from the date of purchase of the Products.

• This warranty extends to you only if you are the end user with the original
purchase receipt.

• We will, at our option, repair or replace the Products that do not conform to
the warranty. We may use functionally equivalent reconditioned/refurbished/
remanufactured/pre-owned or new Products or parts.

• To obtain service in the U.S. contact Plantronics at [phone] and in
Canada call [phone]. If you need additional information, please
contact our service centers at the numbers provided.

• THIS IS PLANTRONICS’ COMPLETE WARRANTY FOR THE PRODUCTS.

• This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state or province to province. Please contact
your dealer or our service center for the full details of our limited warranty,
including items not covered by this limited warranty.

TECHNICAL ASSISTANCE

The Plantronics Technical Assistance Center (TAC) is ready to assist you at

[phone] x5538, or visit the Support section of our website at
www.plantronics.com. For accessibility information also call the Technical
Assistance Center.

www.plantronics.com

Please read the following safety and regulatory instructions before using your
Voyager™ 510 Bluetooth® Headset or Voyager 510S Bluetooth® Wireless Headset
System. Please keep these instructions for your reference.

GENERAL

• Operating and storage temperature 0°C to +45°C.

• Check local laws regarding use of a mobile phone and headset while driving.

• If you use the headset while driving, ensure your attention and focus remain on driving safely.

• Connect the base unit* only to a host terminal port explicitly designated for use with handsets or headsets. Connection
through other ports, such as data ports or line ports, may damage the product and could constitute a fire hazard. If in
doubt, please contact your supplier or the supplier of the host equipment.

• During a power outage, the base unit* will switch to handset mode.

• To prevent temporary malfunction in areas of high electrostatic charge, avoid touching the base unit* charge
contacts.

• Prevent the headset from coming into contact with moisture or liquids.

WARNING

• CHILDREN. Never allow children to play with the headset – small parts may be a choking hazard.

• Observe all signs that require an electrical device or RF radio product to be switched off in designated areas, such
as hospitals, blasting areas, potentially explosive atmospheres, and aircraft.

• On aircraft, obey the airline regulations for use of wireless equipment.

• Keep all products, cords and cables away from operating machinery.

• Never mount or store your headset over any air bag deployment area as serious injury may result when an air
bag deploys.

• Do not insert anything into the headset because this may cause damage to the internal components or cause
injury to you.

BATTERY

CAUTION:
persons, read and follow these instructions.

• Do not attempt to open the headset or remove the battery.

• Do not dispose of the headset or battery in a fire. The battery cells may explode. Check local laws for disposal

• Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to eyes or skin

• Charge the headset according to the instructions supplied with the unit.

RECYCLING:

recycling center for proper disposal of your headset.

CHARGING

Warning:

ous voltages or other risks. Incorrect reassembly can cause electric shock or fire when the product is subsequently
used.

CAUTION

• To reduce the risk of electric shock, explosion or fire use only the supplied charger or Class 2 AC adapter* to

• If the headset becomes hot during charging, disconnect the charger or AC adapter* from the wall and contact

• Do not use the charger, AC adapter* or base unit* outdoors or in damp areas.

CARE

Do not use liquid cleaners or aerosol cleaners as they may damage the headset or finish of the product. Use a dry
cloth to clean the external portions of the product.

* Only applicable to the Voyager 510S Bluetooth Headset System

The headset is equipped with a non-replaceable battery. To reduce the risk of fire or injury to

instructions.

and may be toxic if swallowed.

The battery used in your headset must be recycled or disposed of properly. Contact your local

Do not disassemble the AC adapter* or base unit* of this product as this may expose you to danger-

charge the headset. Ensure that the voltage rating (e.g.120V 60Hz) corresponds to the local mains supply you
intend to use.

qualified service personnel.

©2005 Plantronic s Inc. All rights re served. Printed in USA 70033- 01 ( 06.05)

FCC REQUIREMENTS

Part 68

This equipment complies with Part 68 of the
FCC rules and the requirements adopted
by ACTA. On the exterior of this equipment
is a label that contains a product identifier
in the format US:AAAEQ##TXXXX. If
requested, this information must be
provided to your telephone company.

A plug and jack used to connect this
equipment to the premises wiring and
telephone network must comply with the
applicable FCC Part 68 rules and
requirements adopted by ACTA. A
compliant telephone cord and modular plug
is provided with this product. It is designed
to be connected to a compatible jack that is
also compliant. See installation instructions
for details.

The REN is useful to determine the quantity
of devices you may connect to your
telephone line. Excessive RENs on a
telephone line may result in the devices not
ringing in response to an incoming call. In
most, but not all areas, the sum of the RENs
should not exceed five (5.0). To be certain
of the number of devices you may connect
to your line, as determined by the REN,
contact your local telephone company. For
product approved after July 23, 2001, the
REN for this product is part of the product
identifier that has the format US:
AAAEQ##TXXXX. The digits represented by
### are the REN without the decimal point.
(For example, 03 represents a REN of 0.3.)
For earlier producers, the REN is separately
shown on the label.

If this telephone equipment causes harm to
the telephone network, the telephone
company will notify you in advance that
temporary discontinuance of service may be
required. But if advance notice isn’t practical,
the telephone company will notify the
customer as soon as possible. Also, you will
be advised of your right to file a complaint
with the FCC if you believe it is necessary.

The telephone company may make changes
in its facilities, equipment, operations, or
procedures that could affect the proper
functioning of your equipment. If they do,
you will be notified in advance in order for
you to make necessary modifications to
maintain uninterrupted service.

If trouble is experienced with this unit, for
repair or warranty information, please contact
customer service at [phone] ext.

5538. If the equipment is causing harm to
the network, the telephone company may
request that you disconnect the equipment
until the problem is resolved.

DO NOT DISASSEMBLE THIS EQUIPMENT:
it does not contain any user serviceable
components.

We recommend the installation of an AC
surge arrester in the AC outlet to which this
equipment is connected. Telephone
companies report that electrical surges,
typically lighting transients, are very
destructive to customer terminal equipment
connected to AC power sources.

FCC Requirements — Part 15

This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:

• This device may not cause harmful

interference, and

• This device must accept any interference

received, including interference that may
cause undesired operation.

This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.

However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception which can be determined by
turning the radio or television off and on,
the user is encouraged to try to correct
interference by one or more of the following
measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on

another circuit.

• Consult the dealer or an experienced

radio/TV technician for help.

Exposure to
Radio Frequency Radiation

This device and its antenna must not be co­located or operated in conjunction with any
other antenna or transmitter. To comply with
FCC RF exposure requirements, only use the
supplied antenna.

The radiated output power of this internal
wireless radio is far below the FCC radio
frequency exposure limits. Nevertheless, the
wireless radio shall be used as described in
the manual.

The internal wireless radio operates within
guidelines found in radio frequency safety
standards and recommendations, which
reflect the consensus of the scientific
community.

Plantronics therefore believes the internal
wireless radio is safe for use by consumers.
The level of energy emitted is far less than
the electromagnetic energy emitted by
wireless devices such as mobile phones.
However, the use of wireless radios may be
restricted in some situations or environments,
such as aboard airplanes. If you are unsure
of restrictions, you are encouraged to ask for
authorization before turning on the wireless
radio.

NOTE:

Modifications not expressly
approved by Plantronics, Inc. could void the
user’s authority to operate the equipment.