Plantronics M70 User Manual

SELECT LANGUAGE

GET PAIRED TAKE CONTROL

ADJUST THE FIT

CHARGE

Wearing your headset, power it on. The first time
you do, you will be prompted to select your
language from a set of three options. When
completed, you will hear "pairing", go to the
"settings" menu on your phone to connect to your
headset.

1

When the headset indicator lights flashes red
and blueactivate Bluetooth® on your phone and
set it to search for new devices.

• iPhone* Settings > Bluetooth > On

• Android™ Smartphones* Settings > Wireless &

Networks > Bluetooth: On > Scan for devices

2

If necessary, enter four zeros (0000) for the
passcode or accept the connection.

Once successfully paired, the indicator lights
stops flashing.

Answer or end a call

Tap the Call button .

Decline a call

Press the Call button for 2 seconds.

Adjust the volume

Tap the Volume up (+) or down (–) button.

Mute on

During a conversation, simultaneously tap the
Volume (+) and (–) buttons. You will hear “mute
on”, this voice alert will be repeated once. After
that an alert tone repeats every 15 minutes when
mute is on.

Activate voice dial (phone feature)

Press the Call button for 2 seconds, wait for
the phone prompt and then tell the phone to dial
the name of a stored contact.

Change language

Reselect the headset language at any time by
putting your headset into pair mode.

Press the Call button
flashes red and blue and you hear "pairing, please
select a different language."

Redial

To call your last number dialed, double tap the
Call button

.

until the indicator light

The universal-fit eartip has a thin loop that bends
to gently tuck into the contours of either ear. To
adjust the fit, you can rotate the eartip on the
headset or add the optional clip-on earloop.

For the best voice pickup, always check that the
headset points toward the corner of your mouth.

Your new headset has enough power to pair and
make a few calls. It takes 2 hours to fully charge
the headset; the indicator light turns solid
blue once charging is complete.

FCC statement

This equipment has been tested an d f o un d t o comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protecti on against harmful interference in a residential installation. This
equipment generate, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.

However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation betwee n t he e q uipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

--Consult the dealer or an experienced radio/TV te chnician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

RF exposure warning

· The equipment complies with FCC RF exposure limits set forth for anuncontrolled
environment.

The equipment must not be co-located or operating in conjunction with any other antenna
or transmitter.

NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR
MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE
FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.