Plantronics M165 Owner's Manual

GET STARTED

MARQUE A170

Designed in Santa Cruz, California

™

GET PAIRED

The first time you switch on your headset it
begins the pairing process.

1 While the headset indicator light flashes

red and white, activate Bluetooth® on your
iPhone and set it to search for new devices.

iPhone*

Settings > General > Bluetooth > On
Starts the search for devices.

* Menus may vary by device.

2 Select “PLT_A170.”

3 Once successfully paired, the indicator light

stops flashing red and white and you hear
“pairing successful.”

TAKE CONTROL

Answer a call

Choose:

• Say “answer” after call is announced, or

• Tap the Call Control button

End a call

Tap the Call Control button to end
current call.

Reject a call

Choose:

• Say “ignore” after call is announced, or

• Press Call Control button for 2 seconds

Adjust the volume

Tap the Volume/Mute button / to cycle
through preset levels.

Mute headset

During a conversation, press and hold the
Volume/Mute button / until you hear “mute
on” or “mute off.” While the microphone is
muted, an alert repeats every 15 minutes.

Call back last call

To call your last number dialed, double tap the
Call Control button .

Use call waiting

Double tap the Call Control button to place a
current call on hold and answer a new call from
the same iPhone. Double tap the Call Control
button again to switch between calls. Call
waiting does not work between two paired
iPhones (see Use Two Phones).

Use voice dialing

Press the Call Control button for 2 seconds,
wait for audible prompt depending on your
iPhone and then tell the iPhone to dial the
name of a stored contact.

CHARGE IT

Your new headset has enough power to pair
and make a few calls. It takes two hours to
fully charge the headset; the indicator light
turns off once charging is complete.