Planet Technology PL-420 User Manual
85M Powerline to Ethernet Bridge
with 4-Port Switch
PL-420
User Manual
Copyright
Copyright (C) 2006 PLANET Technology Corp. All rights reserved.
The products and programs described in this User’s Manual are licensed
products of PLANET Technology, This User’s Manual contains proprietary
information protected by copyright, and this User’s Manual and all accompanying
hardware, software, and documentation are copyrighted.
No part of this User’s Manual may be copied, photocopied, reproduced,
translated, or reduced to any electronic medium or machine-readable form by
any means by electronic or mechanical. Including photocopying, recording, or
information storage and retrieval systems, for any purpose other than the
purchaser's personal use, and without the prior express written permission of
PLANET Technology.
Disclaimer
PLANET Technology does not warrant that the hardware will work properly in all
environments and applications, and makes no warranty and representation,
either implied or expressed, with respect to the quality, performance,
merchantability, or fitness for a particular purpose.
PLANET has made every effort to ensure that this User’s Manual is accurate;
PLANET disclaims liability for any inaccuracies or omissions that may have
occurred.
Information in this User’s Manual is subject to change without notice and does
not represent a commitment on the part of PLANET. PLANET assumes no
responsibility for any inaccuracies that may be contained in this User’s Manual.
PLANET makes no commitment to update or keep current the information in this
User’s Manual, and reserves the right to make improvements to this User’s
Manual and/or to the products described in this User’s Manual, at any time
without notice.
If you find information in this manual that is incorrect, misleading, or incomplete,
we would appreciate your comments and suggestions.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against radio interference in a commercial
environment. This equipment can generate, use and radiate radio frequency
energy and, if not installed and used in accordance with the instructions in this
manual, it may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause interference, in which
case the user, at his own expense, will b required to take whatever measure are
necessary to correct the interference.
2
CE mark Warning
The is a class B device, In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.
WEEE
To avoid the potential effects on the environment and human health as
a result of the presence of hazardous substances in electrical and
electronic equipment, end users of electrical and electronic equipment
should understand the meaning of the crossed-out wheeled bin symbol.
Do not dispose of WEEE as unsorted municipal waste and have to
collect such WEEE separately.
Trademarks
The PLANET logo is a trademark of PLANET Technology. This documentation
may refer to numerous hardware and software products by their trade names. In
most, if not all cases, these designations are claimed as trademarks or registered
trademarks by their respective companies.
Revision
User’s Manual for PLANET 85M Powerline to Ethernet Bridge with 4-Port Switch
Model: PL-420
Rev: 1.0 (Feb. 2006)
Part No. : 2081-AE0140-000
3
Table of Content
CHAPTER 1: INTRODUCTION .................................................................................5
OVERVIEW .....................................................................................5
FEATURES .....................................................................................5
SPECIFICATION ...............................................................................6
PACKAGE CONTENTS .....................................................................6
SYSTEM REQUIREMENTS.................................................................6
FRONT PANEL ................................................................................7
WIRE DIAGRAM...............................................................................8
CHAPTER 2: INSTALLATION ..................................................................................9
OVERVIEW......................................................................................9
RUNNING THE INSTALLSHIELD WIZARD..............................................9
CHAPTER 3: CONFIGURATION.............................................................................14
OVERVIEW ...................................................................................14
PART 1: DIAGNOSE A LOCAL POWERLINE DEVICE ...........................14
PART 2: DIAGNOSE A NETWORK POWERLINE DEVICE.......................15
SETTING UP SECURITY ON A LOCAL POWERLINE DEVICE ..................17
SETTING UP SECURITY ON A NETWORK POWERLINE DEVICE.............18
APPENDIX A: TROUBLESHOOTING.......................................................................20
4
Chapter 1: Introduction
Overview
The Planet 85M Powerline to Ethernet Bridge with 4-Port Switch, PL-420,
operates on the HomePlug Powerline Specification 1.0.1 standard for providing
up to 85Mbps bandwidth over home AC wiring. Since the home power lines are
the most pervasive medium in households with multiple outlets in every room, the
PL-420 allows multiple home desktops and notebooks to be networked to share
Internet connections, printers, files, and play games without any additional wiring.
The installation of the 85M Powerline Ethernet Switch only requires that a
10/100Mbps Network Adapter is installed on the computer. This makes the PL420 compatible with any device including Mac, Windows, and Unix machines.
For security reason, the HomePlug devices are equipped with 56-Bit DES
encryption. The private home power grid plus encryption makes HomePlug
significantly more secure than competing technologies. The PL-420 is the best
solution for No-New-Wires home networking. With easy Plug and Play installation,
no need for new wires.
Features
‧ Up to 85Mbps bandwidth over standard home power lines
‧ Estimates range of 300 meters in wall power line
‧ No problem passing through circuit breakers
‧ Easy to manage by connection manager software (Utility)
‧ IEEE 802.3 / IEEE 802.3u Computer interface compliant
‧ Network interface supports 10 Base-T / 100 Base-TX and HomePlug
Powerline
‧ Utility supports Connection Manager Software
‧ Plug-and-Play Installation Support
‧ HomePlug Powerline Specification 1.0.1 compliant
‧ Internal Power Adapter for Power Supply
‧ Utility supports Win98SE / ME / 2K / XP
5
Specification
Model PL-420
Standard HomePlug Powerline Specification 1.0.1
compliant
IEEE 802.3 10Base-T
IEEE 802.3u 100Base-TX
Ports Four RJ-45 ports
Cabling Type Power cord
Speed Up to 85Mbps
Encryption 56-Bits DES encryption
LED
Powerline Frequency
Band
Dimensions 157.4 x 97.9 x 29.5 mm (W x D x H)
Weight
Operating
Temperature
Operating Humidity
Input Voltage
Regulatory
Compliance
PWR, HP, LAN 1-4
4.5Mhz to 21Mhz
210 g (net weight)
0~40 Degree C
10%~90% (non-condensing)
100V~240V AC, 0.2A, 50~60Hz
FCC, CE
Package Contents
• PL-420 x 1
• CD ROM x 1 (user’s manual, utility)
• RJ-45 Ethernet cable x 1
• Quick installation Guide x 1
• Power Cord x 1
System Requirements
• At least 2 Powerline devices
• Available Ethernet ports in the computers
• Available empty power outlet
6
• Standard home power line wiring
• CD-ROM utility
Front Panel
LED definition
LED Description
PWR Steady on indicates when power on
Steady on indicates when find out another HomePlug
HP
Flashing indicates when auto detecting another
HomePlug
LAN
1-4
Steady on indicates LAN port link
Flashing indicates when TX or RX activity
Rear Panel
7
Loading...