Pitco Frialator Pasta Rethermalizer Digital Controller User Manual

PASTA COOKER AND RETHERMALIZER DIGITAL

L20-278 rev 0

CONTROLLER PROGRAMMING INSTRUCTIONS

CONTROLLER FUNCTIONS

SECTION 4.0

PROGRAM KEY

TIMING START/STOP KEYS

OFF

L BASKET/ TIMER

R BASKET/ TIMER

BOIL SIMMER

PROGRAMMING

TIMER PROGRAMMING INSTRUCTIONS

PASSWORD

ENTERING LEVEL 1 PROGRAMMING

Press to turn controller ON

Press and hold for 3 seconds to turn controller OFF

Press to start LEFT timer/basket lift

Press to start RIGHT timer/basket lift

Press , Display will show "BOIL or SIM" Note: Simmer mode runs at 190 F

Press until display shows desired selection

Press for programming mode

Press , Display will show "LOC or Pr09" (Program)

If display shows "LOC" Press then , This will unlock the programming function and allow changes to be made to settings

TIMER SET

Press , Display will show "Pr09" (Program) the indicator lights above both

and functions key will illuminate.

Press or , Display will show "XX" (XX = current timer setting) Indicator above or function key will illuminate to indicate which (left or right) timer is being programmed

Press the or function keys to change set time

Press to save new timer setting

Press to exit programming

UPPER LEVEL PROGRAMMING INSTRUCTIONS

PROGRAMMING

PASSWORD

SIMMER MODE TEMP

SAVE / EXIT

ACTUAL TEMP DISPLAY

T 1, T0

Press , Display will show "LOC or Pr09" (Program)

If display shows "LOC" Press then , This will unlock the programming function and allow changes to be made to settings

Press , Display will show "Pr09" (Program) the indicator lights above both

and functions key will illuminate.

Press and hold for 2 seconds, display will show "XXXF" you are now in SIMMER MODE TEMPERATURE PROGRAMMING (XXXF = current set temperature for the simmer mode)

NOTE: Press and hold to save setting or exit at any time in the programming

sequence.

Press the or function keys to change set temperature

Press , Display will show "T 1 or T 0" (T 1 = actual temperature always appearing display window, T 0 = SIM or BOIL will always appear in display window when controller is operation mode)

PASSWORD SET

BASKET LIFT

ULOC LOC

LIF1

Press , Display will show "LOC or ULOC" (LOC = turns pass word function ON so that a pass word is required to enter programming mode, ULOC = turns pass word requirement OFF)

Press , Display will show "LIF1 or LIF2" (LIF1 = tells the controller that cooker has only a single basket lift, LIF2 = tells the controller cooker has two basket lifts)

TO SAVE SETTINGS OR EXIT PROGRAMMING

NOTE: Press and hold to save setting or exit at any time in the programming sequence.

_ . _ _ F

Boil

Indicates controller is under temperature set point and burners are on

Indicator light, when illuminated, indicates burners are on

Indicates unit is in boil mode

S I M

Indicates unit is in simmer mode