Pitco Frialator Digital Thermostat User Manual
RETHERMALIZER
L20-283 rev 0
DIGITAL THERMOSTAT
PROGRAM
PROGRAMMABLE FUNCTIONS
DF1
HI
LO
CAL
SP1
*
*
*
*
*
Differential temperature - Sets the temperature range above and below the
set temperature that the heating system cycles on and off
Maximum controller temperature - Sets the maximum temperature that can
be programmed into the controller
Minimum controller temperature - Sets the minimum temperature that can be
programmed into the controller
Calibration range - Enables calibration corrections to be made between
actual temperature and sensed temperature at the probe
Set temperature mode - Set temperature is programmed in this mode
ADJUST
180
F
SET
HIDDEN
SET MODE
ENTERING PROGRAMMING MODE
A JUMPER WIRE MUST BE INSTALLED BETWEEN TERMINALS +5 AND -3 ON THE
BACK OF THE CONTROLLER. CONTROLLER IS NON-PROGRAMMABLE WITHOUT
JUMPER WIRE INSTALLED
PROGRAMMING SET TEMPERATURE
*
*
*
*
Press , Display will show “SP1”
(Set temperature mode - Set temperature is programmed in this mode)
Press , Display will show “XXX” (XXX = current set temperature)
Press to change temperature setting (NOTE: If set temperature will
not adjust to desired setting, check HI and LO temperature settings)
Press SET to save new temperature setting
SET
SET
CHANGING PROGRAMMABLE SETTINGS
DF1
HI
LO
CAL
*
*
*
*
*
*
*
*
*
*
*
Press , Display will show "DF1"
Press again, Display will show "XX" (XX = current setting)
Press to change setting
Press again, Display will show "HI"
Press again, Display will show "XXX" (XXX = current setting)
Press to change setting
Press again, Display will show "LO"
Press again, Display will show "XXX" (XXX = current setting)
Press to change setting
Press again, Display will show "CAL"
Press again, Display will show "XX" (XX = current setting) NOTE: This
Number can be set as a NEGATIVE number (-30) or a POSITIVE number
(+30) above or below set point
º F
º F
º F
º F
º F
º F
º F
º F
*
SAVE / EXIT PROGRAMMING MODE
TO SAVE OR EXIT PROGRAMMING MODE AT ANY TIME PRESS ‘F’ UNTIL DISPLAY
SCREEN IS BLANK AND THEN REMOVE JUMPER WIRE.
Press to change setting
Loading...