pioneer Pioneer HPM-100 hpm 100 Operating Guide

HPM
-
100
Before connecting the speakers, turn the amplifier
POWER switch OFF.
Take care to maintain correct polarity (See
Connecting Instructions). Incorrect polarity de­stroys the stereo effect and severely reduces the low frequency response.
Use high quality wire: # 20 gage wire may be used
for distances up to 40 feet. For greater distances use heavier gage wire.
The maximum input power of the HPM-100 is 100
watts. Excess input power may damage speakers or cause unusual noise.
Do not touch any part of the speaker cones.
The nominal impedance of the HPM-100 is 8 ohms.
Speakers may thus be combined with an amplifier whose output terminal impedance is 4 ~ 16 ohms.
The enclosure has a fine finish. Polish the enclosure
periodically with a polishing cloth or a soft dry cloth together with furniture wax. For maximum surface protection, do not use chemicals such as insecticides or volatiles.
LEVEL CONTROLS
Individual controls are provided for the MID and HIGH frequency ranges, and when set at "0" a suggested output characteristic is obtained. Turning either control clockwise increases the output from that speaker, while turning fully counter clockwise reduces the output to zero.
SPECIFICATIONS
Enclosure ........................ Book-shelf style, Bass-reflex type
System ......................................... 4-speaker, 4-way system
Loudspeakers:
Woofer ….. 30cm (12 in.) cone type, carbonfiber cone
Mid-range ................................... 10cm (4 in.) cone type
Tweeter ........................... 4.5cm (1-3/41n.) cone type
Super tweeter ................................... High-polymer type
Nominal Impedance ........................................................... 8
Frequency Range ................................. 30 25,000Hz
Sensitivity ......................... 92.5 dB/W at 1m distance
Maximum Input Power ...................................... 100W
Rated Input Power .............................................. 50W
Crossover frequency 3,000Hz, 4,000Hz, 12,000Hz
External Dimensions ………… 390(W) x 670(H) x 393(D)mm
15.3/8 ( W) x 26-6/16(D) x 15-15/32(D) in
Weight .............................................. 26.7kg/58 lb 12 oz
Specifications and the design subject to possible modifi-
cation without notice due to improvements.
CONNECTING SPEAKERS TO AMPLIFIER
Connect RED (+) terminal of the HPM-100 to the (+) output terminal. of the amplifier, and the BLACK () terminal to the () output terminal of the amplifier. To connect each lead wire, strip
3/4" (20mm) of insolation from the end, press the
appropriate terminal button and insert the wire.
PIONEER ELECTRONIC CORPORATION 4-1. Meguro-Chome, Meguro-kuTokyo 153, Japan. US.PIONEER ELECTRONICS CORPORATION 85 Oxford Drive Moonachie, New Jersey 07074.U.S.A.
PIONEER ELECTRONICS (EUROPE) N.V. Luithagen-Haven 9,2030 Antwerp, Belgium PIONEER ELECTRONICS AUSTRALIA PTY.LTD. 178-184 Boundary Road, Braeside, Victoria 3195, Australia
<77105F3B12> Made in Japan Printed in Japan <SRB-154-0>
S ER IA L NO :
MM- 1V XJ-10815
SPEAKER SYSTEM
O P E R A T I N G G U I D E
Loading...