Pioneer A-30-S User Manual

A-30-S
REAR PANEL
Direct Energy Design Integrated Amplifier with Symmetrical Construction, Aluminium Rotary Knob and Panels, and Phono MM
Direct Energy Design Amp
Symmetrical Power Amp
Clean Ground Construction
Isolated Power Supply
Source Direct Mode
Power Amp Direct Mode
Trans-Stabilizer
Speaker A, B, A+B Selector
Aluminium Rotary Knob
Aluminium Panels
Auto Power Down
CONNECTIONS
Analog ue Au dio Inpu t (PHONO (MM), T UNER, SACD/CD , AUX, NETWORK, RECORDER, POWER AMP DIRECT IN)
Audio Output (RECORDER, PHONES)
SR In/Out
AC Inlet
INTEGRATED TECHNOLOGIES
This logo is used for Pioneer products ca pable of 96 kHz/24-bit or above WAV/FLAC file play­back, and Pi oneer ampli fiers, speakers , or headphon es supporti ng over 4 0 kHz hig h-frequency reproduction, designed to derive maximum performance from Hi-Resolution Audio. This logo is a registered trademark of Japan Audio Society.
PIONEER and the Pioneer logo are registered trademarks of Pioneer Corporation. “SACD” and “Super Audio CD” are trademarks of Sony Corporation
A-30-S/PWSYXE8
SPECIFICATIONS
70 W + 70 W (20 Hz-20 kHz, THD 0.1 %, 4 ohms)
40 W + 40 W (20 Hz-20 kHz, THD 0.05 %, 8 ohms)
THD: 0.01 % (Rated Output -3 dB, 8 ohms, 1 kHz)
Guaranteed Speaker Impedance (2 Speaker Terminals): 4-16 ohms (A or B), 8-32 ohms (A+B), 4-16 ohms (Bi-Wiring)
Frequency Response: SACD/CD 5 Hz-100 kHz, 0 dB/-3 dB, PHONO
(RIAA Equalization) MM 20 Hz-20 kHz, ±0.5 dB
Signal-to-Noise Ratio (IHF, A Network, Short Circuited)
SACD/CD: 105 dB, Phono: 77 dB (MM: 5 mV input), Power Amp Direct: 118 dB
Channel Separation
SACD/CD: 90 dB (100 Hz), 90 dB (1 kHz), 75 dB (10 kHz) Power Amp Direct: 90 dB (100 Hz), 90 dB (1 kHz), 85 dB (10 kHz)
Power Requirements: AC 220-230 V, 50 Hz
Power Consumption: 175 W
Power Consumption During Standby: 0.3 W
Dimensions (W x H x D): 435 x 128 x 360 mm
Weight: 7.9 kg
© 2015 Pioneer Home Electronics Corporation. All rights reserved.
Note: Specifications and design subject to change without notice.
Loading...