Pinnacle Aero Bella AB-716-QH User's Manual And Operating Instructions

User’s Manual and

Infrared Quartz

Operating Instructions

TM

Model: AB-716-QH

Room Furnace

Table of Contents

Safety Information.............................................................2

Product Features..............................................................2

Unpacking and Assembly..................................................2

Operating Instructions.......................................................3

Storage / Maintenance......................................................4

Troubleshooting...............................................................4

Warranty...........................................................................5

Heater is intended for residential use. Do not use outdoors.

CONSUMER: Retain this manual for future reference.

Pinnacle Products International, Inc. 668 Stony Hill Road #302 Yardley, PA 19067 USA

Phone: [phone] Fax: [phone] Web: www.pinnacleint.com Email: [e-mail]

IMPORTANT: Read and understand all of the

directions in this manual before starting the heater.
Improper use of this heater can cause serious injury.
Keep this manual for future reference.

841000100-11

WARNING

WARNING

NEVER LEAVE HEATER

UNATTENDED WHILE

OPERATING

Infrared Quartz

TM

Room Furnace

Safety Information

If the information in this manual is

not followed exactly, a fire, electric
shock or explosion may result causing property dam­age, personal injury or loss of life.

Do not operate this heater until you

have read, and thoroughly under­stand these safety and operating instructions.
Only persons who can read and understand these
instructions should use or service this heater.

- Do not block the intake openings or heated air flow in
any manner.

- Check the heater thoroughly for damage before each
use. DO NOT operate a damaged heater.

- Do not operate heater if the cord or plug is damaged.

- DO NOT modify this heater or operate a heater that has
been modified from it’s original state. Modifying this
heater will void your warranty and could result in injury
and/or death.

- Do not run heater cord below carpeting, throw rugs, run­ners or similar coverings. Do not run heater cord below
furniture or any appliance. Be sure heater cord is out of
traffic areas.

- Do not use this heater in bathrooms, laundry rooms or
similar indoor locations where humidity is high.

- Never operate heater in or near a bathtub, shower or
swimming pool.

- Keep children and animals away from heater.

- Always set heater on a stable, level surface.

- Do not plug this heater into any other cord connect-

ed device such as a power strip, surge protector,
multiple outlet adapter, grounding adpater, outlet­type air fresheners or extension cords. Plug the
heater cord directly into a 3-prong 120V 15 amp
grounded circuit receptacle.

- Never plug heater cord into a loose fitting or broken
receptacle.

- Never use this heater below a receptacle.

- Be sure heater is turned off and fan has completed its
cool down mode before unplugging heater.

- Do not operate this heater near any water.

- Keep heater area free from combustible materials such
as gasoline, paint thinners and other flammable vapors
and liquids. Dust is combustible. Do not use heater in
areas of high dust concentration.

- NEVER leave heater unattended.

- ALWAYS maintain proper distance from combustibles.

- Do not open this heater unless instructed by an author­ized representative of the manufacturer. There are lim­ited user-serviceable parts inside.

Minimum clearance from Combustibles:

TOP SIDES FRONT BACK

24” 12” 72” 36”

Product Features

4 Infrared quartz bulbs: Each infrared quartz bulb is

rated at 375W and warms the air as is passes through the
inner chamber.

Cross flow fan:

air using a cylindrical-shaped impeller.

Delay start function: This function controls the cross flow
fan, and allows the infrared quartz bulbs to heat up before
the fan begins to circulate the air flow. The cross flow fan
will also continue to operate after the heater is turned off to
circulate the warm air out of the heater, cooling the unit
down.

Copper Plate:

constructed from red copper, to enhance and improve
efficiency.

LED Display:

Operating the heater can be done on the unit’s control
panel, or by remote.

The cross flow fan creates a wide flow of

The Diathermanous copper plate is

This displays the temperature and time.

Unpacking and Assembly

- Inspect heater closely for any damage that may have
occurred during shipping. If there is any damage, return
the heater to the place of purchase.

- Remove heater from carton by sliding it out of the box,
and inspect for damages (Save carton and packing
materials for later off-season storage).

- Remove all protective packaging protecting heater
during shipping.

Page 2 Aero Bella Infrared Quartz Room Furnace