Fiber Optic Series
PICO MACOM
PFT
he Pico Macom PFT Series of optical transmitters is available in nine output power levels, from 6 to 14dBm, allowing flexibility in numerous CATV applications. Each unit takes various combinations of input modulated RF signals and converts them
T
to light for distribution to nodes. With an optical wavelength of 1310nm and a bandwidth of 54~860MHz, the transmitter
supports transmission of NTSC and QAM RF signals over a single-mode optical fiber. The PFT Series optical fiber transmitters are
19˝ wide and rack mounted with a height of 1RU.
Se ries
1310nm Optical Transmitters
Features
• Wide bandwidth, 54~860MHz, high-performance
single-mode 1310nm optical fiber transmitter.
• Supports analog and QAM digital applications.
• Wide range laser options, from 6dBm to 14dBm
(4mW to 26mW), for multiple broadband
applications.
• Optical power monitoring of input RF and laser status.
• RS232 port.
• Manual or automatic gain controls RF input level.
• Automatic gain controlled input allows unit to maintain
the same optical output with varying inputs without
distortion.
• Input voltage between 90-260Vac.
• Unit can be used for NTSC and PAL systems.
• Front panel RF test port -20dB.
• Low power consumption.
www.picomacom.com
1
Ph: 858-546-5050 Toll Free: 800-421-6511 Fax: 858-546-5051
6260 Sequence Drive San Diego, CA 92121
Rev. 9/07
PICO MACOM
90-240VAC
47-63HZ
REMOTE CONTROLRF IN OPTICAL OUT
1310 nm OPTICAL TRANSMITTER STATUSSTATUS RF AGC ON/OFFRF AGC ON/OFF
MGC
ADJUST
LASER
LASER ON/OFFLASER ON/OFF
RF
AGC
MGC
RFRF RF TEST PORT
PFT-1310mn Optical Transmitter
Fiber Optic Series
Front View
Rear View
Specifications
Optical Output
Power in dBm: 6, 7, 8, 9, 10, 11, 12, 13, 14 dBm
Optical Wavelength: 1310nm
Laser Type: DFB
Optical Connector Type: SC/APC (FC/APC Optional)
RF Frequency Range: 50~860 MHz
RF Input Level Range: +15 to 20dBmV
RF Input Impedance: 75Ω
In-Band Flatness: ±1dB
Input Return Loss: >15dB
Carrier-to-Noise (CNR)*: >50dB
Composite Second
Order (CSO)*: >60dB
Composite Triple Beat(CTB)*: >65dB
AGC Control Range: ±5dB
MGC Control Range: ±5dB
Power Supply Range: 90-264 Vac
Power Consumption (typical): 30 watts
Operating Temperature: 0° to 50°C
Storage Temperature: -20° to +65°C
Relative Humidity: <10%
Dimensions: 19˝ W x 13˝ D x 1.75˝ H
Weight: 9.15 lbs.
Ordering Information
PFT - 6 (6dBm or 4mW) - 1310nm Optical Transmitter
PFT - 7 (7dBm or 5mW) - 1310nm Optical Transmitter
PFT - 8 (8dBm or 7mW) - 1310nm Optical Transmitter
PFT - 9 (9dBm or 8mW) - 1310nm Optical Transmitter
PFT - 10 (10dBm or 10mW) - 1310nm Optical Transmitter
PFT - 11 (11dBm or 14mW) - 1310nm Optical Transmitter
PFT - 12 (12dBm or 16mW) - 1310nm Optical Transmitter
PFT - 13 (13dBm or 20mW) - 1310nm Optical Transmitter
PFT - 14 (14dBm or 26mW) - 1310nm Optical Transmitter
2
* Test results are typical and were performed at our San Diego test center using an 80 channel NTSC Matrix generator as the RF source, appropriate optical
loss budget for the 1310nm transmitter being tested and optical receiver input level of -1dBm.
6260 Sequence Drive San Diego, CA 92121
Rev. 9/07
Ph: 858-546-5050 Toll Free: 800-421-6511 Fax: 858-546-5051
www.picomacom.com
Loading...