Philips TDA7021T Datasheet
INTEGRATED CIRCUITS
DATA SH EET
TDA7021T
FM radio circuit for MTS
Product specification
File under Integrated Circuits, IC01
May 1992
Philips Semiconductors Product specification
FM radio circuit for MTS TDA7021T
GENERAL DESCRIPTION
The TDA7021T integrated radio receiver circuit is for portable radios, stereo as well as mono, where a minimum of
periphery is important in terms of small dimensions and low cost. It is fully compatible for applications using the
low-voltage micro tuning system (MTS). The IC has a frequency locked loop (FLL) system with an intermediate frequency
of 76 kHz. The selectivity is obtained by active RC filters. The only function to be tuned is the resonant frequency of the
oscillator. Interstation noise as well as noise from receiving weak signals is reduced by a correlation mute system.
Special precautions have been taken to meet local oscillator radiation requirements. Because of the low intermediate
frequency, low pass filtering of the MUX signal is required to avoid noise when receiving stereo. 50 kHz roll-off
compensation, needed because of the low pass characteristic of the FLL, is performed by the integrated LF amplifier.
For mono application this amplifier can be used to directly drive an earphone. The field-strength detector enables
field-strength dependent channel separation control.
Features
• RF input stage
• Mixer
• Local oscillator
• IF amplifier/limiter
• Frequency detector
• Mute circuit
• MTS compatible
• Loop amplifier
• Internal reference circuit
• LF amplifier for
− mono earphone amplifier or
− MUX filter
• Field-strength dependent channel separation control
facility
QUICK REFERENCE DATA
PARAMETER CONDITIONS SYMBOL MIN. TYP. MAX. UNIT
Supply voltage (pin 4) V
Supply current V
= 3 V l
P
RF input frequency f
= V
P
4
rf
1,8 − 6,0 V
4-3
− 6,3 − mA
1,5 − 110 MHz
Sensitivity (e.m.f.) for source impedance = 75 Ω;
−3 dB limiting mute disabled EMF − 4 −µV
Signal handling (e.m.f.) source impedance = 75 Ω EMF − 200 − mV
AF output voltage V
o
− 90 − mV
PACKAGE OUTLINE
16-lead mini-pack; plastic (SO 16; SOT109A); SOT109-1; 1996 July 24.
May 1992 2
This text is here in white to force landscape pages to be rotated correctly when browsing through the pdf in the Acrobat reader.This text is here in
_white to force landscape pages to be rotated correctly when browsing through the pdf in the Acrobat reader.This text is here inThis text is here in
white to force landscape pages to be rotated correctly when browsing through the pdf in the Acrobat reader. white to force landscape pages to be ...
May 1992 3
Philips Semiconductors Product specification
FM radio circuit for MTS TDA7021T
Fig.1 Block diagram.
Philips Semiconductors Product specification
FM radio circuit for MTS TDA7021T
RATINGS
Limiting values in accordance with the Absolute Maximum System (IEC 134)
PARAMETER CONDITIONS SYMBOL MIN. MAX. UNIT
Supply voltage (pin 4) V
Oscillator voltage V
Storage temperature range T
Operating ambient temperature range T
THERMAL RESISTANCE
P
5-4
stg
amb
= V
4-3
− 7,0 V
VP−0,5 VP+ 0,5 V
−55 +150 °C
−10 +70 °C
From junction to ambient R
DC CHARACTERISTICS
= 3 V, T
V
P
= 25 °C, measured in circuit of Fig.4, unless otherwise specified
amb
PARAMETER CONDITIONS SYMBOL MIN. TYP. MAX. UNIT
Supply voltage (pin 4) V
Supply current V
= 3 V I
P
Oscillator current I
Voltage at pin 13 V
Output voltage (pin 14) V
4
5
P
13-3
14-3
= V
4-3
1,8 3,0 6,0 V
− 6,3 − mA
− 250 −µA
− 0,9 − V
− 1,3 − V
th j-a
300 K/W
Fig.2 Supply current as a function of the supply voltage.
May 1992 4
Loading...