Page 1
Register your product and get support at
www.philips.com/welcome
EN Quick start guide
Wireless HiFi Headphone
SHD8600
Page 2
A
a
bc
d
efg
Quick start guide
BC
Page 3
DE
F
Page 4
EN
1 What’s in the box (Fig. A)
1) Headphones 2) Docking station
3) AC/DC adaptor 4) 3.5 - 6.3mm adaptor
5) RCA to 3.5mm audio cable 6) Quick star t guide
7) 2 x AAA rechargeable NiMH batteries (SBC HB700)
2 Get Started
Note
Before using the headphones for the fi rst time, charge the supplied batteries for •
at least 4 hours.
If the volume of the audio source is insuffi cient, the transmitter automatically turns •
off.
The energizing docking station does not transmit audio signal during charge. •
1
Install/Replace supplied batteries (Fig. B).
2 Power on/off the headphones (Fig. C)
3 Power on the transmitter (Fig. D).
Charge the headphones (Fig. E).•
4 Connect audio and adjust ATT (Attenuation of audio input signal)
(Fig. F).
For por table CD player, MP3 player or other devices with 3. 5mm •
triport socket output, switch AT T to 0dB .
For HiFi, TV, DVD player or other devices with RCA socket output, •
switch ATT to -8dB . (Fig. G: Jack to cinch connector, not supplied).
For an audio device with a 6.3mm headphone output, use the supplied •
3.5mm - 6.3mm stereo adaptor plug (Fig. A).
Page 5
3 LED indication
Connection
established
Charging (≤ 70% full) Green LED on Transmitter Fast
Charging (> 70% full) Green LED on Transmitter Slow
Charging (100% full) Green LED on Transmitter On
Battery low Blue LED on Headphones Fast
Searching Blue LED on Headphones Slow
Blue LED on Transmitter &
Headphones
On
blinking
blinking
blinking
blinking
4 Sound indication
One “Beep” Battery is low.
“Beep, Beep” Battery goes out soon.
Aler t “Beep” Volume at max/min vol. level.
For further product suppor t, please visit www.philips.com/welcome
5 Adaptor specification
Region Adaptor type
number
China SCV-005-050-
055-A2
HK SBH-005-050-
055-A2
AUS & NZ SSH-005-050-
055-A2
Input
voltage
100 -240V 5V 550mA 50/60Hz
100 -240V 5V 550mA 50/60Hz
100 -240V 5V 550mA 50/60Hz
Output
voltage
Input frequency
Page 6
6 Important
Hearing Safety
Danger
To avoid hearing damage, limit the time you use the headphones at high volume and •
set the volume to a safe level. The louder the volume, the shorter is the safe listening
time.
Be sure to observe the following guidelines when using your headphones.
Listen at reasonable volumes for reasonable periods of time.•
Be careful not to adjust the volume continuously upwards as your •
hearing adapts.
Do not turn up the volume so high that you can’t hear what’s around •
you.
You should use caution or temporarily discontinue use in potentially •
hazardous situations.
Excessive sound pressure from earphones and headphones can cause •
hearing loss.
Electric-, Magnetic- and Electromagnetic Fields (EMF)
1. Royal Philips Electronics manufactures and sells many products targeted at
consumers, which, like any electronic apparatus, in general have the ability
to emit and receive electromagnetic signals.
2. One of Philips’ leading Business Principles is to take all necessary health
and safety measures for our products, to comply with all applicable legal
requirements and to stay well within the EMF standards applicable at the
time of producing products.
3. Philips is committed to develop, produce and market products that cause
no adverse health effects.
4. Philips confi rms that if its products are handled properly for their intended
use, they are safe to use according to scientifi c evidence available today.
5. Philips plays an active role in the development of international EMF and
safety standards, enabling Philips to anticipate fur ther developments in
standardization for early integration in its products.
Page 7
General information
• To prevent fi re or shock hazard : Always keep this product dry.
Do not expose it to excessive heat by heating equipment or direct
sunlight.
No naked fl ame sources, such as lighted candles, should be placed on •
the apparatus.
Do not allow your headset to be submerged in water. •
• To clean the product : Use a slightly dampened chamois cloth. Do not
use cleansing agents containing alcohol, spirits, ammonia or abrasives
as they may harm the product.
Do not disassemble the product. •
Transmission range: 15 meters, depending on ambient conditions.•
Do not operate or store the product in a place where temperature •
is below 0°C (32°F) or above 40°C (104°F) as this may shorten the
battery life.
Apparatus shall not be exposed to dripping or splashing.•
The mains plug of AC/DC adaptor is used as the disconnect device, •
the disconnect device shall be readily operable.
Only use Philips’ rechargeable shortened sleeve NiMH batteries with •
your headphones.
Other types of rechargeable or alkaline batteries cannot be charged •
with this system.
AAA alkaline batteries can be used to operate the headphones.•
Batteries (battery pack or batteries installed) shall not be exposed to •
excessive heat such as sunshine, fi re or the like.
Disposal of your old product
Your product is designed and manufactured with high quality materials and
components, which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a product it
means that the product is covered by the European Directive 2002/96/
EC.
Please inform yourself about the local separate collection system for electrical
and electronic products.
Please act according to your local rules and do not dispose of your old
products with your normal household waste. Correct disposal of your
old product helps to prevent potential negative consequences for the
environment and human health.
Page 8
Your product contains batteries covered by the European Directive 2006/66/
EC, which cannot be disposed with normal household waste.
Please inform yourself about the local rules on separate collection of
batteries because correct disposal helps to prevent negative consequences
for the environmental and human health.
Attention should be drawn to the environmental aspects of battery disposal.
Notice for the European Union
Hereby, Philips Consumer Lifestyle, BU P&A, declares that this Philips
digital wireless headset SHD8600 is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
This product has been designed, tested and manufactured according to the
European R&TTE Directive 1999/5/EC.
Page 9
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
Specifications are subject to change without notice.
Trademarks are the property of Koninklijke Philips Electronics N.V.
or their respective owners.
SHD8600_93_QSG_V1.1
Loading...